When the ignition switch is ON, operating the rear window defogger switch activates the rear window defogger.
w/o Automatic Air Conditioning System:
The rear window defogger control is performed by the main body ECU (network gateway computer). When the main body ECU (network gateway computer) receives an on signal from the rear window defogger switch, it operates the RR DEF relay for 15 minutes. Also, when the main body ECU (network gateway computer) receives an off signal from the rear window defogger switch within 15 minutes, it stops operation of the RR DEF relay.
w/ Automatic Air Conditioning System:
The rear window defogger control is performed by the main body ECU (network gateway computer). When the rear window defogger switch is turned on, a rear window defogger activation request signal from the air conditioner control assembly is sent to the main body ECU (network gateway computer) via the CAN communication line, and the main body ECU (network gateway computer) operates the RR DEF relay for 15 minutes. Also, when the main body ECU (network gateway computer) receives a rear window defogger off signal within 15 minutes, it stops operation of the RR DEF relay.
Perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before performing the following inspection (See page Vehicle Exterior>WINDOW / GLASS>WINDOW DEFOGGER SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body / Main Body / Active Test.
According to the display on the GTS, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Rear Defogger | RR DEF relay | OFF or ON | - |
The window defogger system operates normally.
| Result | Proceed to |
|---|---|
| NG | A |
| OK | B |
A
B
Remove the RR DEF relay from the engine room relay block.
Inspect the RR DEF relay (See page Vehicle Exterior>WINDOW / GLASS>RELAY>ON-VEHICLE INSPECTION).
OK
NG
Remove the RR DEF relay from the engine room relay block assembly.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 - Body ground | Ignition switch ON | 11 to 14 V |
| 3 - Body ground | Always | 11 to 14 V |
| *1 | Engine Room Relay Block |
| *2 | RR DEF Relay |
OK
NG
Remove the RR DEF relay from the engine room relay block assembly.
Disconnect the A73 main body ECU (network gateway ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 - A73-24 | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 - Body ground | Always | 10 kΩ higher |
| Result | Proceed to |
|---|---|
| NG | A |
| OK (w/o Automatic Air Conditioning System) | B |
| OK (w/ Automatic Air Conditioning System) | C |
A
B
C
Disconnect the D6 main body ECU (network gateway ECU) connector.
Disconnect the D22 heater control sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| D6-5 - D22-2 (RDEF+) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| D6-5 - Body ground | Always | 10 kΩ or higher |
OK
NG
Remove the heater control sub-assembly (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING PANEL(for Manual Air Conditioning System)>REMOVAL ).
Inspect the heater control sub-assembly (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING PANEL(for Manual Air Conditioning System)>INSPECTION).
OK
NG
Disconnect the G10 and H29 rear window defogger connector.
Remove the RR DEF relay from the engine room relay block assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G10-1 - 5 | Always | Below 1 Ω |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| H29-1 - Body ground | Always | Below 1 Ω |
| G10-1 - Body ground | Always | 10 kΩ or higher |
OK
NG