Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEEL
47710A
2.SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY
43512
3.REMOVE FRONT DISC
for floating type caliper: Click hereBrake>BRAKE (FRONT)>FRONT BRAKE (for Floating Type Caliper)>REMOVAL
for opposed type caliper: Click hereBrake>BRAKE (FRONT)>FRONT BRAKE(for Opposed Type Caliper)>REMOVAL
89543
4.DISCONNECT FRONT SPEED SENSOR LH
Remove the bolt and disconnect the front speed sensor LH from the steering knuckle.
Clean the speed sensor installation hole and the contact surfaces every time the front speed sensor LH is removed.
43502C
5.REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH
Remove the 4 bolts and front axle hub sub-assembly LH from the steering knuckle.