Home › Brake › BRAKE (REAR) › REAR BRAKE (for Opposed Type Caliper) › from 2017.03
RM2090E _54 Brake _060687 BRAKE (REAR) _0313979 REAR BRAKE(for Opposed Type Caliper) A

BRAKE (REAR)  REAR BRAKE(for Opposed Type Caliper)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RH and LH sides.

·

The procedure listed below is for LH side.



PROCEDURE

Hide 42431 1.INSTALL REAR DISC

a.

When reusing the rear disc

i.

Align the matchmarks placed when removing, and install the rear disc to the axle hub.



b.

When replacing the rear disc

i.

Install a new rear disc to the axle hub and measure the disc runout (See page Brake>BRAKE (REAR)>REAR BRAKE (for Opposed Type Caliper)>INSPECTION).

HINT:

When using a new rear disc, install it so that rear disc runout is minimum.




c.

Temporarily tighten the hub nuts and fix the rear disc to the axle hub.


Hide 3.INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG

a.

Install the parking brake shoe adjusting hole plug to the rear disc.


Hide 4.INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY LH

a.

Install the rear disc brake cylinder assembly LH with the 2 bolts.

Torque:
73 N*m (744 kgf*cm, 54 ft.*lbf)


Hide 5.INSTALL REAR DISC BRAKE PAD KIT

a.
C375086

Apply disc brake grease to the rear disc brake pad and rear No. 1 disc brake anti squeal shim.

Text in Illustration
V100144

Disc Brake Grease


b.

Install the rear disc brake pad to the rear disc brake cylinder assembly LH.

HINT:

Install the rear No. 1 disc brake anti squeal shim so that the arrow mark faces up.



c.

Install the rear No. 1 disc brake pad support plate, 2 rear No. 1 disc brake rear cylinder slide pins, and 2 slid pin clips.


Hide 47319F 6.CONNECT REAR FLEXIBLE HOSE LH

a.

Connect the rear left flexible hose LH with 2 new gaskets and a new union bolt.

Torque:
26 N*m (265 kgf*cm, 19 ft.*lbf)


Hide 9.INSPECT BRAKE FLUID LEAK

Hide 11.INSTALL REAR WHEEL

Torque:
120 N*m (1224 kgf*cm, 89 ft.*lbf)