Home › Power Source / Network › FA20 (BATTERY / CHARGING) › CHARGING SYSTEM (for 150 A Type) › from 2019.03
RM2090E _57 Power Source / Network _060693 FA20 BATTERY / CHARGING _0396238 CHARGING SYSTEM(for 150 A Type) C

FA20 BATTERY / CHARGING  CHARGING SYSTEM(for 150 A Type)  P1C00  Battery Monitor Module Performance  


DESCRIPTION

The ECM outputs DTC P1C00 when the following conditions are met.

DTC No. DTC Detection Condition Trouble Area
P1C00 The IBS information about the abnormality in the battery temperature sensor, battery voltage sensor or battery current sensor is received when less than 1 second has elapsed after the ignition switch is turned to ON. Battery state sensor (battery negative terminal)

PROCEDURE

1.CHECK FOR DTC
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch ON.


c.

Turn the GTS on.



e.

Turn the ignition switch off and wait at least 30 seconds.


f.

Enter the following menus: Powertrain / Engine / Trouble Codes.



Result:
Result Proceed to
DTC P1C00 is output A
DTC is not output B


OK

REPLACE BATTERY STATE SENSOR (BATTERY NEGATIVE TERMINAL)

NG