Home › Power Source / Network › FA20 (BATTERY / CHARGING) › CHARGING SYSTEM (for 150 A Type) › from 2019.03
RM2090E _57 Power Source / Network _060693 FA20 BATTERY / CHARGING _0396238 CHARGING SYSTEM(for 150 A Type) C

FA20 BATTERY / CHARGING  CHARGING SYSTEM(for 150 A Type)  U171F  LIN Communication Error with Generator  


DESCRIPTION

The ECM outputs DTC U171F when the following conditions are met.

DTC No. DTC Detection Condition Trouble Area
U171F Either of the following conditions is met for 2 seconds:
Condition 1
·

The battery voltage is 10.9 V or more.

·

The information that the ECM receives via LIN communication is not updated or the checksum error is detected.


Condition 2
·

The battery voltage is 10.9 V or more.

·

The generator assembly internal failure flag (communication error alert) is set.


·

Generator assembly

·

Wire harness or connector



CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK FOR DTC
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch ON.


c.

Turn the GTS on.



e.

Turn the ignition switch off and wait at least 30 seconds.


f.

Enter the following menus: Powertrain / Engine / Trouble Codes.



Result:
Result Proceed to
DTC U171F is output A
DTC is not output B


A

2.CHECK HARNESS AND CONNECTOR

NG

2.CHECK HARNESS AND CONNECTOR
a.

Turn the ignition switch off.


b.

Check that the connector is properly connected to the ECU.

OK:

The connector is securely connected.




OK

3.CHECK GENERATOR POSITIVE TERMINAL

NG

CONNECT THE ENGINE CONTROL COMPUTER CONNECTOR PROPERLY

3.CHECK GENERATOR POSITIVE TERMINAL
a.

Turn the ignition switch off.


b.

Disconnect the ground terminal from the battery state sensor (battery negative terminal).


c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
Generator assembly (+) terminal - Body ground Always Battery voltage




OK

4.CHECK HARNESS AND CONNECTOR (ECM - GENERATOR ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS AND CONNECTOR

4.CHECK HARNESS AND CONNECTOR (ECM - GENERATOR ASSEMBLY)
a.

Disconnect the ECM connector.


b.

Disconnect the generator assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A33-21 (LIN) - A80-1 (C) Always Below 1 Ω




OK

NG

REPAIR OR REPLACE HARNESS AND CONNECTOR