Home › Power Source / Network › FA20 (BATTERY / CHARGING) › CHARGING SYSTEM (for 150 A Type) › from 2019.03
RM2090E _57 Power Source / Network _060693 FA20 BATTERY / CHARGING _0396238 CHARGING SYSTEM(for 150 A Type) C

FA20 BATTERY / CHARGING  CHARGING SYSTEM(for 150 A Type)  P0563  System Voltage High  


DESCRIPTION

The ECM outputs DTC P0563 when the following conditions are met.

DTC No. DTC Detection Condition Trouble Area
P0563 Either of the following conditions is met for 30 seconds:
Condition 1
·

The final output duty cycle of generator assembly power generation control is 50% or more.

·

The battery voltage is 16.2 V or more.


Condition 2
·

The engine speed is 500 rpm or more.

·

The battery voltage is 16.2 V or more.


·

Generator assembly

·

Battery state sensor (battery negative terminal)

·

ECM



CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK GENERATOR ASSEMBLY
a.

Start the engine.


b.

Idling with warm engine.


c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
Generator assembly positive (+) terminal - Body ground Always Less than 16.2 V




OK

2.CHECK GENERATOR ASSEMBLY

NG

2.CHECK GENERATOR ASSEMBLY
a.

Start the engine.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
Generator assembly positive (+) terminal - Body ground Engine Speed: 3000 rpm Less than 16.2 V




OK

3.CHECK FOR DTC

NG

3.CHECK FOR DTC
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch ON.


c.

Turn the GTS on.



e.

Turn the ignition switch off and wait at least 30 seconds.


f.

Enter the following menus: Powertrain / Engine / Trouble Codes.



Result:
Result Proceed to
DTC P0563 is output A
DTC is not output B


A

B