The flat type knock sensor (non-resonant type) has a structure that can detect vibration in a wider band of frequency from about 6 kHz to 15 kHz and has the following features:
The knock sensor is fitted on the cylinder block to detect engine knocking.
The sensor contains a piezoelectric element which generates voltage when it becomes deformed. This occurs when the cylinder block vibrates due to knocking. If engine knocking occurs, the ignition timing is retarded to suppress it.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P0325 | Knock Sensor 1 Circuit | Open or short in knock sensor circuit for more than 0.9 seconds
(1 trip detection logic) |
·
Open or short in knock sensor circuit ·
Knock sensor ·
Knock sensor installation ·
ECM |
Comes on | DTC stored |
If the ECM detects DTC P0325, it enters fail-safe mode in which the corrective retarded angle value is set to the maximum value.
Reference: Inspection using an oscilloscope
| Tester Connection | Tool Setting | Condition | Specified Condition |
|---|---|---|---|
| C24-13 (KNK) - C24-33 (E2) | 1 V/DIV, 2 msec./DIV | After warming up the engine, keep the engine speed at 4000 rpm | The correct waveform is as shown |
The oscilloscope waveform shown as an example does not include noise or chattering waveforms.
The waveform amplitudes differ slightly depending on the vehicle conditions.
Read freeze frame data using an intelligent tester. Freeze frame data record the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data, from the time the malfunction occurred.
| *a | Rear view of wire harness connector
(to ECM) |
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connections | Condition | Specified Conditions |
|---|---|---|
| C24-13 (KNK) - C24-33 (E2) | 20°C (68°F) | 120 to 280 kΩ |
Reconnect the ECM connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the knock sensor installation.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Clear the DTCs.
Start the engine.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read DTCs.
| Result | Proceed to |
|---|---|
| No output | A |
| P0325 (for LHD) | B |
| P0325 (for RHD) | C |
A
B
C
Inspect the knock sensor.
Click hereEngine / Hybrid System>3SZ-VE ENGINE CONTROL>KNOCK SENSOR>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG