28100
1.INSTALL STARTER ASSEMBLY
Install the starter assembly with the 2 bolts while inclining the transmission.
Use a union nut wrench to tighten the lower bolt.
Position the engine wire as illustrated and install it with the nut.
Connect the starter assembly connector.
Operate the transmission jack, and then temporarily install the engine assembly with transmission.
Do not raise the engine more than necessary. If the engine is raised excessively, the vehicle may also be lifted up.
Make sure that the engine is clear of all wiring and hoses.
While raising the engine into the vehicle, do not allow it to contact the vehicle.
51022
2.INSTALL REAR ENGINE SUPPORT MEMBER SUB-ASSEMBLY
Install the rear engine support member sub-assembly with the 6 bolts.
3.CONNECT CONNECTOR
33820B
4.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
5.INSTALL CLUTCH RELEASE CABLE ASSEMBLY
17410
6.INSTALL FRONT EXHAUST PIPE ASSEMBLY
37100
7.TEMPORARILY TIGHTEN PROPELLER SHAFT ASSEMBLY
37100
8.FULLY TIGHTEN PROPELLER SHAFT ASSEMBLY
9.ADD MANUAL TRANSMISSION OIL
10.INSPECT MANUAL TRANSMISSION OIL
11.INSPECT FOR MANUAL TRANSMISSION OIL LEAK
11452
12.INSTALL OIL LEVEL DIPSTICK GUIDE