Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE SHAFT
RM19Y0E _52 Drivetrain _002987 AXLE AND DIFFERENTIAL _0015118 REAR AXLE SHAFT A

AXLE AND DIFFERENTIAL  REAR AXLE SHAFT  INSTALLATION  


PROCEDURE

Hide 42311A 1.INSTALL REAR AXLE SHAFT OIL SEAL

a.

Apply MP grease to the lip of a new oil seal.


b.
C144889N01
1.542,0.958 2.188,0.854 2.188,0.854 1.875,1.135 true 2.302,0.75 3.021,1.146 0.719,0.396 10 SST

Using SST and a hammer, install the oil seal.

SST
09517-12010  
09950-70010  (09951-07150)


Hide 42340B 2.INSTALL REAR AXLE SHAFT ASSEMBLY LH

C144879N02
1.885,0.521 2.156,0.458 false 2.24,0.385 2.927,0.75 0.688,0.365 10 SST

a.

Insert the axle shaft LH into the rear axle housing using SST.

SST
09520-00031  

NOTICE:

Be careful not to damage the oil seal.



b.

w/o ABS

i.

Install 4 new setting bolts to the rear axle housing.



c.

Install the bearing retainer to the backing plate with the 4 nuts.

Torque:
42 N*m (425 kgf*cm, 31 ft.*lbf)


Hide 89546 4.INSTALL REAR SPEED SENSOR LH (w/ ABS)

a.

Install the speed sensor LH to the rear axle housing with the bolt.

Torque:
8.4 N*m (86 kgf*cm, 74 in.*lbf)

NOTICE:
·

Prevent foreign matter from attaching to the sensor tip.

·

Clean the installation hole before installing the sensor.




Hide 42403 5.INSTALL REAR BRAKE DRUM SUB-ASSEMBLY

Hide 6.ADJUST REAR DRUM BRAKE SHOE CLEARANCE

Hide 7.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 9.INSPECT FOR OIL LEAK