Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › 2011.11–2015.08
RM19Y0E _54 Brake _002992 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0015137 ANTI-LOCK BRAKE SYSTEM J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  Brake Warning Light Remains ON  


DESCRIPTION

When one of the following conditions is met, the brake warning light remains on:

·

The brake fluid level is insufficient.

·

The parking brake is applied.

·

The PKB terminal circuit is shorted.


WIRING DIAGRAM

C249019E02
3.271,0.833 4,1.229 0.729,0.396 10 BRAKE 0.99,4.125 1.479,4.469 0.49,0.344 10 J5 2.167,2.385 2.427,2.729 0.26,0.344 10 + 1.354,2.385 1.677,2.688 0.323,0.302 10 - 0.99,4.302 3.875,4.938 2.885,0.635 10 PARKING BRAKE SWITCH ASSEMBLY 0.99,2.635 1.448,3 0.458,0.365 10 A7 0.99,2.813 4.479,3.479 3.49,0.667 10 BRAKE FLUID LEVEL WARNING SWITCH (BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY) 2.135,1.448 2.771,1.771 0.635,0.323 10 E34 2.135,1.615 4.604,2.052 2.469,0.438 10 COMBINATION METER ASSEMBLY 2.323,2.375 2.729,2.729 0.406,0.354 10 1 2.323,3.781 2.667,4.115 0.344,0.333 10 1 1.208,2.375 1.521,2.781 0.313,0.406 10 2 5.594,3.885 6.396,4.396 0.802,0.51 10 PKB 5.354,3.792 5.771,4.135 0.417,0.344 10 30 2.177,0.552 2.594,0.802 0.417,0.25 10 IG 4.021,0.552 4.51,0.854 0.49,0.302 10 PKB 1.927,0.552 2.313,0.896 0.385,0.344 10 39 4.396,0.552 4.698,0.833 0.302,0.281 10 9 0.292,0.635 1.646,1.167 1.354,0.531 10 from IG Circuit 4.979,4.552 5.563,4.948 0.583,0.396 10 B10 4.979,4.74 6.969,5.49 1.99,0.75 10 SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY)

CAUTION / NOTICE / HINT

NOTICE:

If the brake actuator is replaced with a new one, the skid control ECU (brake actuator assembly) makes the shift to test mode automatically when the ignition switch is turned to ON for the first time. Be sure to complete the test mode checks (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>TEST MODE PROCEDURE).


PROCEDURE

1.INSPECT BRAKE FLUID LEVEL WARNING SWITCH
a.

Turn the ignition switch to ON.


b.

With the brake fluid at the specified level, disconnect the brake fluid level warning switch (brake master cylinder reservoir sub-assembly) connector and check the brake warning light.

Result:
Result Proceed to
Brake warning light does not turn off A
Brake warning light turns off B


HINT:

If the brake warning light turns off, the brake fluid level warning switch (brake master cylinder reservoir sub-assembly) has an internal short circuit.




A

2.INSPECT PARKING BRAKE SWITCH ASSEMBLY

B

REPLACE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY

2.INSPECT PARKING BRAKE SWITCH ASSEMBLY
a.

Turn the ignition switch off.


b.

Remove the parking brake switch.

Click hereBrake>PARKING BRAKE>PARKING BRAKE SWITCH>REMOVAL


c.

Inspect the parking brake switch.

Click hereBrake>PARKING BRAKE>PARKING BRAKE SWITCH>INSPECTION

Result:
Proceed to
OK
NG




OK

3.CHECK HARNESS AND CONNECTOR (BRAKE WARNING LIGHT CIRCUIT)

NG

REPLACE PARKING BRAKE SWITCH ASSEMBLY

3.CHECK HARNESS AND CONNECTOR (BRAKE WARNING LIGHT CIRCUIT)
a.

Turn the ignition switch off.


b.

Disconnect the B10 skid control ECU (brake actuator assembly) connector.


c.

Disconnect the E34 combination meter connector.


d.

Disconnect the J5 parking brake switch connector.


e.

Disconnect the A7 brake fluid level warning switch (brake master cylinder reservoir sub-assembly) connector.


f.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
B10-30 (PKB) - E34-9 (PKB) Always Below 1 Ω
B10-30 (PKB) - Body ground Always 10 kΩ or higher


Result:
Proceed to
OK
NG




OK

4.INSPECT SKID CONTROL ECU (PKB INTERNAL CIRCUIT)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.INSPECT SKID CONTROL ECU (PKB INTERNAL CIRCUIT)
a.

Turn the ignition switch off.


b.

Release the parking brake.

Click hereBrake>PARKING BRAKE>PARKING BRAKE SWITCH>INSTALLATION


c.

Start the engine.


d.

Disconnect the B10 skid control ECU (brake actuator assembly) connector and check the brake warning light.

Result:
Result Proceed to
Brake warning light does not turn off A
Brake warning light turns off B


HINT:

If the brake warning light turns off, the skid control ECU (brake actuator assembly) has an internal short circuit.




A

GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

B