Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR › 2011.11–2015.08
RM19Y0E _54 Brake _002992 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0015138 BRAKE ACTUATOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE ACTUATOR  INSTALLATION  


PROCEDURE

Hide 44547B 1.INSTALL BRAKE ACTUATOR BRACKET CUSHION

a.

Install the 3 brake actuator bracket cushions.


Hide 44590 2.INSTALL BRAKE ACTUATOR BRACKET ASSEMBLY

a.

Using a 6 mm hexagon wrench, install the brake actuator bracket assembly with the 3 hexagon bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 44510 3.INSTALL BRAKE ACTUATOR ASSEMBLY

a.

Install the brake actuator assembly with brake actuator bracket assembly with the 3 bolts.

Torque:
20 N*m (199 kgf*cm, 14 ft.*lbf)


b.

Using union nut wrench, install each brake line into the correct position of the brake actuator assembly.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



c.
C249540

Connect the connector and push the lock lever downward.

NOTICE:

Make sure that the connector is locked securely.



d.

Connect the wire harness clamp to the brake actuator bracket assembly.


Hide 4. FILL RESERVOIR WITH BRAKE FLUID

Hide 5.BLEED CLUTCH LINE (for 3SZ-VE with Manual Transmission)

Hide 47201 6.BLEED MASTER CYLINDER

Hide 9.INSPECT FOR BRAKE FLUID LEAK

Hide 10.INSPECT BRAKE ACTUATOR USING INTELLIGENT TESTER