Home › Brake › BRAKE SYSTEM (OTHER) › PROPORTIONING VALVE › 2011.11–2015.08
RM19Y0E _54 Brake _002993 BRAKE SYSTEM (OTHER) _0015147 PROPORTIONING VALVE A

BRAKE SYSTEM (OTHER)  PROPORTIONING VALVE  INSTALLATION  


PROCEDURE

Hide 47190 1.INSTALL PROPORTIONING AND BY-PASS VALVE ASSEMBLY

a.

Install the proportioning and by-pass valve assembly with the 2 bolts.

Torque:
7.9 N*m (81 kgf*cm, 70 in.*lbf)


b.

Using union nut wrench, install the 5 brake tubes onto the proportioning and by-pass valve assembly.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 2. FILL RESERVOIR WITH BRAKE FLUID

Hide 3.BLEED CLUTCH LINE (for 3SZ-VE with Manual Transmission)

Hide 7.INSPECT FOR BRAKE FLUID LEAK