44610
1.INSTALL BRAKE BOOSTER ASSEMBLY
Provisionally install the brake master cylinder push rod clevis onto the brake booster assembly.
Tighten the push rod lock nut when adjusting the brake pedal height.
Install a new gasket onto the brake booster assembly.
Install the brake booster assembly with the 4 nuts.
47264D
2.INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS
3.INSPECT AND ADJUST BRAKE BOOSTER PUSH ROD
44773F
4.CONNECT UNION TO CHECK VALVE HOSE
Connect the union to check valve hose to the brake booster with the clip.
47201
5.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY
31481
6.INSTALL CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE (for 3SZ-VE with Manual Transmission)
Install the clutch reservoir grommet, clutch hose and clutch tube.
Using union nut wrench, install the clutch tube onto the clutch master cylinder.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Using union nut wrench, install the brake tube onto the clutch orifice.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
31481A
7.INSTALL NO. 1 CLUTCH HOSE (for 3SZ-VE with Manual Transmission)
Connect the No. 1 clutch hose to the clutch master cylinder with the clip.
Connect the No. 1 clutch hose to the brake master cylinder with the clip.
8.INSPECT FOR CLUTCH FLUID LEAK (for 3SZ-VE with Manual Transmission)
9.INSPECT FOR BRAKE FLUID LEAK
47101
10.INSPECT AND ADJUST BRAKE PEDAL
45287
11.INSTALL LOWER STEERING COLUMN COVER