Home › Brake › BRAKE (FRONT) › FRONT BRAKE FLEXIBLE HOSE › 2011.11–2015.08
RM19Y0E _54 Brake _002994 BRAKE (FRONT) _0015152 FRONT BRAKE FLEXIBLE HOSE A

BRAKE (FRONT)  FRONT BRAKE FLEXIBLE HOSE  INSTALLATION  


PROCEDURE

Hide 47313A 1.INSTALL FRONT FLEXIBLE HOSE

a.

Install the front flexible hose with the union bolt and a new gasket.

Torque:
30 N*m (310 kgf*cm, 22 ft.*lbf)

HINT:

Install the front flexible hose lock securely into the lock hole in the disc brake cylinder assembly.



b.

Install the front flexible hose with the bolt.

Torque:
17 N*m (175 kgf*cm, 13 ft.*lbf)


c.

Install the front flexible hose with a new clip.


d.

Using union nut wrench, install the brake tube to the front flexible hose while holding the front flexible hose with a wrench.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 2. FILL RESERVOIR WITH BRAKE FLUID

Hide 3.BLEED CLUTCH LINE (for 3SZ-VE with Manual Transmission)

Hide 7.INSPECT FOR BRAKE FLUID LEAK

Hide 8.INSTALL FRONT WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)