Home › Brake › BRAKE (FRONT) › FRONT BRAKE › 2011.11–2015.08
RM19Y0E _54 Brake _002994 BRAKE (FRONT) _0015153 FRONT BRAKE A

BRAKE (FRONT)  FRONT BRAKE  INSTALLATION  


PROCEDURE

Hide 47722 1.INSTALL FRONT DISC BRAKE CYLINDER MOUNTING

a.

Install the front disc brake cylinder mounting onto the steering knuckle with the 2 bolts.

Torque:
113 N*m (1150 kgf*cm, 83 ft.*lbf)


Hide 2.INSTALL FRONT DISC BRAKE BUSH DUST BOOT

a.
C223516C02
3.063,4.563 3.302,4.563 false
V100144

Lithium Soap Base Glycol Grease


Apply a light layer of lithium soap base glycol grease to the entire circumference of 2 new front disc brake bush dust boots as shown in the illustration.

HINT:

Apply at least 0.3 g (0.01 oz.) of lithium soap base glycol grease to each front disc brake bush dust boot.



b.

Install the 2 dust boots onto the front disc brake cylinder mounting.


Hide 47715A 3.INSTALL FRONT DISC BRAKE CYLINDER SLIDE PIN

a.

Apply a light layer of lithium soap base glycol grease to the entire circumference of the 2 front disc brake cylinder slide pins.


b.

Install the 2 slide pins onto the front disc brake cylinder mounting.


Hide 4.INSTALL FRONT DISC BRAKE PAD SUPPORT PLATE

a.

Install the 2 front disc brake pad support plates onto the front disc brake cylinder mounting.


Hide 04945 5.INSTALL FRONT ANTI SQUEAL SHIM KIT

a.
C324746C02
2.115,1.781 2.365,1.781 false 0.833,1.417 1.083,1.417 false 1.094,1.333 1.406,1.531 0.313,0.198 10 false *1 1.948,1.688 2.26,1.885 0.313,0.198 10 false *2
*1 Pad wear indicator plate
*2 Anti squeal shim


Install the anti squeal shim onto the brake pad (outer).


b.

Install the pad wear indicator plate onto the brake pad (inner).

NOTICE:
·

When replacing worn pads, the anti squeal shim must be replaced together with the pads.

·

Install the shim in the correct position and direction.




Hide 04465 6.INSTALL FRONT DISC BRAKE PAD KIT

a.

Install the front disc brake pad kit onto the front disc brake cylinder mounting.

NOTICE:

There should be no oil or grease on the friction surfaces of the disc brake pads or the front disc.



Hide 47750 7.INSTALL DISC BRAKE CYLINDER ASSEMBLY

a.

Install the disc brake cylinder assembly onto the front disc brake cylinder mounting with the 2 bolts.

Torque:
37 N*m (380 kgf*cm, 28 ft.*lbf)


Hide 47313A 8.INSTALL FRONT FLEXIBLE HOSE

a.

Install the front flexible hose with the union bolt and a new gasket.

Torque:
30 N*m (310 kgf*cm, 22 ft.*lbf)

HINT:

Install the front flexible hose lock securely into the lock hole in the disc brake cylinder assembly.



Hide 9. FILL RESERVOIR WITH BRAKE FLUID

Hide 10.BLEED CLUTCH LINE (for 3SZ-VE with Manual Transmission)

Hide 14.INSPECT FOR BRAKE FLUID LEAK

Hide 15.INSTALL FRONT WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)