Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › 2011.11–2015.08
RM19Y0E _55 Steering _002997 POWER ASSIST SYSTEMS _0015160 POWER STEERING SYSTEM G

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1. CHECK STEERING EFFORT (TORQUE)

a.

Stop the vehicle on a level, paved road and align the wheels facing straight ahead.


b.

Disconnect the cable from the negative (-) battery terminal.


c.

Remove the steering pad (See page Steering>STEERING COLUMN>STEERING WHEEL>REMOVAL).


d.

Connect the cable to the negative (-) battery terminal.


e.

Using a torque wrench, check that the steering wheel set nut is properly tightened.

Torque:
34 N*m (350 kgf*cm, 25 ft.*lbf)


f.

Turn the ignition switch to ON (the engine is stopped) so that the power steering is ready to operate.


g.
C167530

Turn the steering wheel 90 degrees to the right and check the steering effort (torque) while continuing to turn it further in the same direction.

Steering effort (Reference):

5.5 N*m (56 kgf*cm, 49 in.*lbf) or less



h.

Align the front wheels facing straight ahead.


i.

Disconnect the cable from the negative (-) battery terminal.


j.

Install the steering pad (See page Steering>STEERING COLUMN>STEERING WHEEL>INSTALLATION).


k.

Connect the cable to the negative (-) battery terminal.


l.

Clear the DTCs (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).

Chassis > EMPS > Clear DTCs
50002 317

Hide 45102 2.CHECK STEERING WHEEL FREEPLAY

a.

Turn the ignition switch to ON so that the power steering is ready to operate.


b.

Align the wheels facing straight ahead.


c.

Gently turn the steering wheel right and left with your finger and check the steering wheel freeplay.

Maximum freeplay:

30 mm (1.2 in.)


HINT:

If the freeplay is outside the specifications, replace steering intermediate shaft assembly or the power steering gear with a new one.