Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING PANEL › from 2015.08
RM19Y0E _58 Vehicle Interior _003013 HEATING / AIR CONDITIONING _0015236 AIR CONDITIONING PANEL A

HEATING / AIR CONDITIONING  AIR CONDITIONING PANEL  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55501A 2.REMOVE GLOVE COMPARTMENT DOOR SUB-ASSEMBLY

Hide 73970A 3.REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

Hide 55412D 4.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 55420A 5.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 55910R 6.REMOVE HEATER CONTROL ASSEMBLY

a.

for RHD w/o Heater:

i.

Disengage the clamp and disconnect the air inlet damper control cable sub-assembly.

E322270



b.

for RHD w/ Heater:

i.

Disengage the 3 clamps and disconnect the 3 cables as shown in the illustration.

E239133



c.

for LHD w/o Heater:

i.

Disengage the clamp and disconnect the air inlet damper control cable sub-assembly.

E325112



d.

for LHD w/ Heater:

i.

Disengage the 3 clamps and disconnect the 3 cables as shown in the illustration.

E239134



e.
E231820

Disengage the 2 claws.


f.

Disengage the 2 guides.


g.

w/ Heater:

i.
E325895

Disconnect the 2 connectors and remove the heater control assembly.



h.

w/o Heater:

i.
E322271

Disconnect the 2 connectors and remove the heater control assembly.



Hide 55908A 7.REMOVE AIR INLET DAMPER CONTROL CABLE SUB-ASSEMBLY

a.

for RHD:

i.
E322272

Spread the 2 claws.


ii.

Pull out the outer cable to remove the air inlet damper control cable sub-assembly.



b.

for LHD:

i.
E325113

Spread the 2 claws.


ii.

Pull out the outer cable to remove the air inlet damper control cable sub-assembly.



Hide 55909A 8.REMOVE AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY

a.

for RHD:

i.
E325114

Spread the 2 claws.


ii.

Pull out the outer cable to remove the air mix damper control cable sub-assembly.



b.

for LHD:

i.
E325115

Spread the 2 claws.


ii.

Pull out the outer cable to remove the air mix damper control cable sub-assembly.



Hide 55906A 9.REMOVE DEFROSTER DAMPER CONTROL CABLE SUB-ASSEMBLY

a.

for RHD:

i.
E325116

Spread the 2 claws.


ii.

Pull out the outer cable to remove the defroster damper control cable sub-assembly.



b.

for LHD:

i.
E325117

Spread the 2 claws.


ii.

Pull out the outer cable to remove the defroster damper control cable sub-assembly.