Home › Vehicle Interior › HEATING / AIR CONDITIONING › CONDENSER › from 2015.08
RM19Y0E _58 Vehicle Interior _003013 HEATING / AIR CONDITIONING _0193103 CONDENSER A

HEATING / AIR CONDITIONING  CONDENSER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RHD and LHD vehicles.

·

The procedure listed below is for the RHD vehicle.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 2.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM

Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 52119A 4.REMOVE FRONT BUMPER COVER

Hide 86510 5.REMOVE HIGH PITCHED HORN ASSEMBLY

Hide 53629 6.REMOVE NO. 2 HOOD LOCK CONTROL CABLE COVER (for Tropic)

Hide 88561J 7.REMOVE UPPER AIR INLET GRILLE (except Tropic)

Hide 88561L 9.REMOVE LOWER AIR INLET GRILLE

a.
E321252

Remove the 2 clips.


b.

Disengage the 2 claws to remove the lower air inlet grille.


Hide 53208A 10.REMOVE HOOD LOCK SUPPORT SUB-ASSEMBLY

a.
E321253

Remove the 2 bolts and hood lock support sub-assembly.


Hide 88711 11.DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

E322263

a.

Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the cooler condenser assembly.


b.

Remove the O-ring from the No. 1 cooler refrigerant discharge hose.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.



Hide 88716A 12.DISCONNECT COOLER REFRIGERANT LIQUID PIPE A

a.
E322264

Remove the bolt and disconnect the cooler refrigerant liquid pipe A from the cooler condenser assembly.


b.

Remove the O-ring from the cooler refrigerant liquid pipe A.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.



Hide 88460 13.REMOVE COOLER CONDENSER ASSEMBLY

E322265

a.

Remove the 4 bolts and the cooler condenser assembly.

NOTICE:

Do not damage the cooler condenser assembly or radiator assembly when removing the cooler condenser assembly.