Home › Vehicle Interior › HEATING / AIR CONDITIONING › CONDENSER › from 2015.08
RM19Y0E _58 Vehicle Interior _003013 HEATING / AIR CONDITIONING _0193103 CONDENSER A

HEATING / AIR CONDITIONING  CONDENSER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RHD and LHD vehicles.

·

The procedure listed below is for the RHD vehicle.



PROCEDURE

Hide 88460 1.INSTALL COOLER CONDENSER ASSEMBLY

a.

Install the cooler condenser assembly into the vehicle with the 4 bolts.

NOTICE:

Do not damage the cooler condenser assembly or radiator assembly when installing the condenser assembly.


HINT:

If a new cooler condenser assembly is installed, add compressor oil to the cooler condenser assembly as follows.


Capacity:

Add 20 cc (0.68 fl.oz)


Compressor oil:

ND-OIL8 or equivalent.



Hide 88716A 2.CONNECT COOLER REFRIGERANT LIQUID PIPE A

a.

Remove the attached vinyl tape from the cooler refrigerant liquid pipe A and the connecting part of the cooler condenser assembly.


b.

Apply sufficient compressor oil to a new O-ring and the fitting surface of the cooler refrigerant liquid pipe A joint.

Compressor oil:

ND-OIL8 or equivalent



c.

Install the O-ring onto the cooler refrigerant liquid pipe A.


d.

Install the cooler refrigerant liquid pipe A onto the cooler condenser assembly with the bolt.

Torque:
6.2 N*m (63 kgf*cm, 55 in.*lbf)


Hide 88711 3.CONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

a.

Remove the attached vinyl tape from the No. 1 cooler refrigerant discharge hose and the connecting part of the cooler condenser assembly.


b.

Apply sufficient compressor oil to a new O-ring and the fitting surface of the No. 1 cooler refrigerant discharge hose joint.

Compressor oil:

ND-OIL8 or equivalent



c.

Install the O-ring onto the No. 1 cooler refrigerant discharge hose.


d.

Install the No. 1 cooler refrigerant discharge hose onto the cooler condenser assembly with the bolt.

Torque:
6.2 N*m (63 kgf*cm, 55 in.*lbf)


Hide 53208A 4.INSTALL HOOD LOCK SUPPORT SUB-ASSEMBLY

a.

Install the hood lock support sub-assembly with the 2 bolts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


Hide 88561L 5.INSTALL LOWER AIR INLET GRILLE

a.

Engage the 2 claws.


b.

Install the air inlet grille with the 2 clips.


Hide 88561J 7.INSTALL UPPER AIR INLET GRILLE (except Tropic)

Hide 53629 8.INSTALL NO. 2 HOOD LOCK CONTROL CABLE COVER (for Tropic)

Hide 86510 9.INSTALL HIGH PITCHED HORN ASSEMBLY

Hide 52119A 10.INSTALL FRONT BUMPER COVER

Hide 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
6.4 N*m (65 kgf*cm, 57 in.*lbf)

Hide 13.WARM UP ENGINE