Home › Engine / Hybrid System › 1NR-VE ENGINE MECHANICAL › CYLINDER HEAD GASKET › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042273 1NR-VE ENGINE MECHANICAL _0196180 CYLINDER HEAD GASKET A

1NR-VE ENGINE MECHANICAL  CYLINDER HEAD GASKET  REMOVAL  


PROCEDURE

Hide 11103 1.REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY

Hide 25051 2.REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY

Hide 16591A 4.REMOVE RADIATOR PIPE RADIATOR HOSE

A360077

a.

Loosen the hose clamp and remove the radiator pipe radiator hose.


Hide 16261 5.DISCONNECT WATER BY-PASS HOSE

a.
A360078

Loosen the clamp and disconnect the water by-pass hose.


Hide 6.REMOVE HARNESS BRACKET

a.
A360079

Disconnect the engine coolant temperature sensor connector.


b.

Remove the bolt and harness bracket.


Hide 7.REMOVE WATER BY-PASS HOSES

a.
A360080

w/ Heater:

i.

Loosen the clamp and disconnect the No. 5 water by-pass hose with the No. 2 water by-pass hose and No. 3 water by-pass hose.



b.

w/o Heater:

i.

Loosen the clamp and disconnect the No. 5 water by-pass hose with the water by-pass hose and No. 3 water by-pass hose.



Hide 11101 8.REMOVE CYLINDER HEAD SUB-ASSEMBLY

a.
A286216N02
0.438,0.281 0.594,0.479 0.156,0.198 10 3 0.969,0.26 1.125,0.458 0.156,0.198 10 5 1.479,0.271 1.688,0.469 0.208,0.198 10 10 2.063,0.26 2.219,0.458 0.156,0.198 10 8 2.594,0.271 2.75,0.469 0.156,0.198 10 2 2.583,1.844 2.74,2.042 0.156,0.198 10 4 2.073,1.865 2.229,2.063 0.156,0.198 10 6 1.521,1.865 1.677,2.063 0.156,0.198 10 9 0.969,1.865 1.125,2.063 0.156,0.198 10 7 0.448,1.854 0.604,2.052 0.156,0.198 10 1

Using a 10 mm bi-hexagon wrench, uniformly loosen and remove the 10 cylinder head set bolts and 10 plate washers in several steps and in the order shown in the illustration.

NOTICE:
·

Removing the cylinder head set bolts in the wrong order may cause warpage or cracking of the cylinder head sub-assembly.

·

Do not drop the plate washers into the cylinder head sub-assembly.




b.

Using a screwdriver with its tip wrapped with tape, pry between the cylinder head sub-assembly and cylinder block sub-assembly, and remove the cylinder head sub-assembly.

NOTICE:

Be careful not to damage the contact surfaces of the cylinder head sub-assembly and cylinder block sub-assembly.



Hide 11115 9.REMOVE CYLINDER HEAD GASKET

a.
A360081

Remove the cylinder head gasket from the cylinder block sub-assembly.


Hide 11101A 10.INSPECT CYLINDER HEAD SET BOLT