Home › Engine / Hybrid System › 1NR-VE LUBRICATION › OIL PRESSURE SWITCH › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042283 1NR-VE LUBRICATION _0196245 OIL PRESSURE SWITCH A

1NR-VE LUBRICATION  OIL PRESSURE SWITCH  INSTALLATION  


PROCEDURE

Hide 83530 1.INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

a.
A085603C09
1.198,0.313 1.51,0.469 0.313,0.156 10 *a
*a Adhesive 1344


Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent



b.
A361321

Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Install the engine oil pressure switch assembly within 3 minutes of applying adhesive.

·

Do not start the engine for at least 1 hour after installation.




c.

Connect the engine oil pressure switch assembly connector.


Hide 12311 2.INSTALL FRONT NO. 1 ENGINE MOUNTING BRACKET RH

a.
A363037N01
1.646,1.271 2.01,1.552 0.365,0.281 10 true 3 (A) 0.438,0.99 0.615,1.229 0.177,0.24 10 true 1 1.583,0.292 1.76,0.531 0.177,0.24 10 true 2

Temporarily install the front No. 1 engine mounting bracket RH with the bolt (A).


b.

Temporarily install the 2 bolts.


c.

Fully tighten the 3 bolts in the order shown in the illustration.

Torque:
44 N*m (449 kgf*cm, 32 ft.*lbf)


d.

Install the front engine mounting insulator with the 2 new bolts.

Torque:
34 N*m (347 kgf*cm, 25 ft.*lbf)


Hide 88320 3.INSTALL COOLER COMPRESSOR ASSEMBLY (w/ Air Conditioning System)

Hide 16361A 4.INSTALL FAN AND GENERATOR V BELT

Hide 17775A 5.INSTALL NO. 3 AIR CLEANER PIPE BRACKET

Hide 17750A 6.INSTALL AIR CLEANER INLET ASSEMBLY

Hide 9.INSTALL CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
6.4 N*m (65 kgf*cm, 57 in.*lbf)