Home › Engine / Hybrid System › 2NR-VE STARTING › STARTER(for Manual Transmission) › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042286 2NR-VE STARTING _0196258 STARTER(for Manual Transmission) A

2NR-VE STARTING  STARTER(for Manual Transmission)  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

NOTICE:

Do not let a tool come into contact with the film seal on the starter commutator end frame assembly.


a.

Install the starter assembly with the 2 bolts.

Torque:
46 N*m (469 kgf*cm, 34 ft.*lbf)


b.

Connect the starter assembly connector.


c.

Connect the engine wire with the nut.

Torque:
12.8 N*m (131 kgf*cm, 9 ft.*lbf)


Hide 11363A 2.INSTALL FLYWHEEL HOUSING SIDE COVER

a.
A361762

Insert the protruding portion of the flywheel housing side cover into the end of the cylinder block sub-assembly and while pushing it along the cylinder block sub-assembly, engage the claw with the cylinder block sub-assembly.

NOTICE:
·

Make sure that the claw makes a click sound, indicating a tight fit.

·

Replace the flywheel housing side cover with a new one if it does not engage securely or is deformed.




Hide 51022 3.INSTALL REAR ENGINE SUPPORT MEMBER SUB-ASSEMBLY

a.

Operate the transmission jack and install the rear engine support member sub-assembly with the 4 bolts.

Torque:
39 N*m (398 kgf*cm, 29 ft.*lbf)


Hide 17410 5.SET FRONT EXHAUST PIPE ASSEMBLY

Hide 58151A 6.INSTALL NO. 1 FLOOR HEAT INSULATOR

Hide 17410 7.INSTALL FRONT EXHAUST PIPE ASSEMBLY

Hide 37110 8.INSTALL PROPELLER SHAFT ASSEMBLY

Hide 11.INSPECT FOR MANUAL TRANSMISSION OIL LEAK

Hide 11452 12.INSTALL OIL LEVEL DIPSTICK GUIDE

Hide 13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
6.4 N*m (65 kgf*cm, 5 ft.*lbf)