Home › Engine / Hybrid System › 2NR-VE STARTING › STARTER(for Manual Transmission) › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042286 2NR-VE STARTING _0196258 STARTER(for Manual Transmission) A

2NR-VE STARTING  STARTER(for Manual Transmission)  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 11452 2.REMOVE OIL LEVEL DIPSTICK GUIDE

Hide 37110 4.REMOVE PROPELLER SHAFT ASSEMBLY

Hide 17410 5.DISCONNECT FRONT EXHAUST PIPE ASSEMBLY

Hide 58151A 6.REMOVE NO. 1 FLOOR HEAT INSULATOR

Hide 17410 7.REMOVE FRONT EXHAUST PIPE ASSEMBLY

Hide 51022 9.SEPARATE REAR ENGINE SUPPORT MEMBER SUB-ASSEMBLY

a.
A359662

Support the rear engine support member sub-assembly with a transmission jack.

NOTICE:

Check that the rear engine support member sub-assembly is centered on the transmission jack plate.



b.
A361764

Remove the 4 bolts and separate the rear engine support member sub-assembly from the vehicle.


c.
A361765C01
3.094,1.271 3.406,1.427 0.313,0.156 10 false *a
*a 45 mm (1.772 in.)


Lower the transmission jack until the clearance between the rear engine support member sub-assembly and the vehicle is approximately 45 mm (1.772 in.).


Hide 11363A 10.REMOVE FLYWHEEL HOUSING SIDE COVER

a.
A361761

Disengage the claw by pulling the flywheel housing side cover outward and remove the flywheel housing side cover.


Hide 28100 11.REMOVE STARTER ASSEMBLY

NOTICE:

Do not let a tool come into contact with the film seal on the starter commutator end frame assembly.


a.
A359664C02
2.479,1.823 2.281,1.375 true 2.427,1.885 2.74,2.042 0.313,0.156 10 false *1
*1 Film Seal
V100135

Connector
V100136

Nut


Disconnect the starter assembly connector.


b.

Remove the nut and disconnect the engine wire.


c.
A359665

Remove the 2 bolts and the starter assembly.