51443
1.REMOVE NO. 2 ENGINE UNDER COVER (w/ No. 2 Engine Under Cover)
51473A
2.REMOVE ENGINE SIDE COVER SUB-ASSEMBLY RH
3.DRAIN ENGINE COOLANT
89465A
4.REMOVE NO. 2 OXYGEN SENSOR (w/ Air Fuel Ratio Sensor)
17410
5.DISCONNECT FRONT EXHAUST PIPE ASSEMBLY
| *1 | No. 2 Exhaust Pipe Support |
|
Bolt |
|
Nut |
Remove the 2 nuts, 4 bolts and 2 compression springs.
Disconnect the No. 2 exhaust pipe support.
58151A
6.REMOVE NO. 1 FLOOR HEAT INSULATOR
17410
7.REMOVE FRONT EXHAUST PIPE ASSEMBLY
17451
8.REMOVE EXHAUST PIPE GASKET
Remove the exhaust pipe gasket from the front exhaust pipe assembly.
Remove the exhaust pipe gasket from the exhaust manifold converter sub-assembly.
16281
9.DISCONNECT NO. 4 WATER BY-PASS HOSE
Loosen the clip and disconnect the No. 4 water by-pass hose.
27020
10.REMOVE GENERATOR ASSEMBLY
89465
11.REMOVE OXYGEN SENSOR (w/o Air Fuel Ratio Sensor)
89467B
12.REMOVE AIR FUEL RATIO SENSOR (w/ Air Fuel Ratio Sensor)
45220
13.SEPARATE STEERING INTERMEDIATE SHAFT ASSEMBLY (for LHD)
17118
14.REMOVE MANIFOLD STAY
Remove the 2 bolts and manifold stay.
17167
15.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
Remove the 5 nuts and No. 1 exhaust manifold heat insulator.
25051
16.REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY
Remove the 5 nuts and exhaust manifold converter sub-assembly.
17173
17.REMOVE EXHAUST MANIFOLD TO HEAD GASKET
Remove the exhaust manifold to head gasket from the cylinder head sub-assembly.
17168
18.REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR
Remove the 3 bolts and No. 2 exhaust manifold heat insulator from the exhaust manifold converter sub-assembly.