Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM › from 2015.08
RM19Y0E _58 Vehicle Interior _003006 THEFT DETERRENT / KEYLESS ENTRY _0015192 ENGINE IMMOBILISER SYSTEM Y

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use these procedures to troubleshoot the engine immobiliser system.

·

*: Use the GTS or Techstream.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.

HINT:

A simple method to determine whether the battery is depleted is to operate the horn.


Result:
Proceed to
NEXT



NEXT

3.CRANK ENGINE FOR MORE THAN 10 SECONDS
3.CRANK ENGINE FOR MORE THAN 10 SECONDS
Result:
Proceed to
NEXT



NEXT

4.CHECK FOR DTC*
4.CHECK FOR DTC*
a.

Check for DTCs and note any codes that are output.

i.

Engine Immobiliser System

Body Electrical > IMB > Trouble Codes
50001 586



b.

Based on the DTCs output above, proceed to each diagnostic procedure.

Result:
Result Proceed to
DTC is not output A
SFI system (for 1NR-VE) DTC is output B
SFI system (for 2NR-VE (w/ Air Fuel Ratio Sensor)) DTC is output C
SFI system (for 2NR-VE (w/o Air Fuel Ratio Sensor)) DTC is output D
Engine immobiliser system DTC is output E




A

5.PROBLEM SYMPTOMS TABLE

B

C

D

E

5.PROBLEM SYMPTOMS TABLE
a.

Refer to Problem Symptoms Table.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in problem symptoms table A
Fault is listed in problem symptoms table B




A

6.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

7.ADJUST , REPAIR OR REPLACE
6.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

7.ADJUST , REPAIR OR REPLACE
7.ADJUST , REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

8.CHECK FOR DTC*
8.CHECK FOR DTC*
a.

Clear the DTCs.

Body Electrical > IMB > Clear DTCs
50002 586

b.

Check for DTCs.

Body Electrical > IMB > Trouble Codes
50001 586
HINT:

Before checking for DTCs, perform the "DTC Output Confirmation Operation" of each diagnostic procedure.


Result:
Result Proceed to
DTC is not output A
Engine immobiliser system DTC is output B




A

END

B