51443
1.REMOVE NO. 2 ENGINE UNDER COVER (w/ No. 2 Engine Under Cover)
45250
2.REMOVE STEERING COLUMN ASSEMBLY
3.DRAIN CLUTCH FLUID
83100
4.REMOVE COMBINATION METER ASSEMBLY (for LHD)
55545
5.REMOVE FUSE BOX OPENING COVER (for LHD)
84340
6.REMOVE STOP LIGHT SWITCH ASSEMBLY (for LHD)
84520
7.REMOVE CLUTCH START SWITCH ASSEMBLY (for LHD)
8.DISCONNECT CONNECTOR (for RHD)
Detach the 2 harness clamps from the clutch pedal bracket.
Disconnect the connector from the clutch start switch assembly.
31481A
9.DISCONNECT NO. 1 CLUTCH HOSE
Disconnect the No. 1 clutch hose.
Use container to collect the fluid.
31481
10.SEPARATE CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE
Using union nut wrench (10 mm), separate the clutch master cylinder to flexible hose tube.
Use container to collect the fluid.
44610
11.REMOVE BRAKE BOOSTER ASSEMBLY (for LHD)
55106
12.REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY (for LHD)
13.REMOVE CLUTCH PEDAL BRACKET (for RHD)
Remove the nut and 2 bolts and remove the clutch pedal bracket.
31410
14.REMOVE CLUTCH MASTER CYLINDER ASSEMBLY
Remove the clip, wave washer and the pin and separate the clutch master cylinder push rod clevis from the clutch pedal sub-assembly.
Remove the bolt and nut and remove the clutch master cylinder assembly.