The input speed sensor are installed on the case side face. The rotational sensor adopts the magnetic type rotational sensor that applies to the hall element to detect the number of revolutions accurately.
The input speed sensor detects the number of revolutions of the front clutch drum (the number of the sensor rotor teeth is 30).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate | Memory | Note |
|---|---|---|---|---|---|---|---|
| P0717 | Turbine Speed Sensor Malfunction | 1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
1.
Ignition switch ON and shift lever not in P or N 2.
A transmission revolution sensor (input speed sensor) signal malfunction is not detected 3.
2 seconds 4.
1-trip detection logic |
·
Open or short in transmission revolution sensor (input speed sensor) circuit ·
Transmission revolution sensor (input speed sensor) ·
ECM |
Come on | Blinks | DTC stored | - |
MIL:"Comes on" means the MIL (Malfunction Indicator Light) illuminates.
Memory:"DTC stored" means the ECM stores the trouble code if the ECU detects the DTC detection condition.
Disconnect the C44 transmission revolution sensor (input speed sensor) connector.
Disconnect the C50 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C44-1 (VCC) - C50-47 (VBTB) | Always | Below 1 Ω |
| C44-2 (VOUT) - C50-69(RTBN) | Always | Below 1 Ω |
| C44-3 (GND) - C50-91 (ETBN) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C44-1 (VCC) or C50-47 (VBTB) - Body ground | Always | 10 kΩ or higher |
| C44-2 (VOUT) or C50-69(RTBN) - Body ground | Always | 10 kΩ or higher |
| C44-3 (GND) or C50-91 (ETBN) - Body ground | Always | 10 kΩ or higher |
Reconnect the C44 transmission revolution sensor (input speed sensor) connector.
Reconnect the C50 ECM connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereDrivetrain>A4R AUTOMATIC TRANSMISSION / TRANSAXLE>SPEED SENSOR>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS or Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the GTS or Techstream on.
Enter the following menus: Powertrain / A/T / Trouble Codes.
Refer to Road Test.
Click hereDrivetrain>A4R AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSMISSION SYSTEM>ROAD TEST
Enter the following menus: Powertrain / A/T / Trouble Codes.
Check if diagnosis code P0717 is output.
When not using the GTS or Techstream, refer to DTC CHECK / CLEAR.
Click hereDrivetrain>A4R AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSMISSION SYSTEM>DTC CHECK / CLEAR
| Display (DTC Output) | Proceed to |
|---|---|
| P0717 (for 1NR-VE) | A |
| P0717 (for 2NR-VE) | B |
| NO DTC | C |
A
B
C