The ECM uses the signals from the throttle position, engine speed and input speed, to monitor the engagement condition of the lock-up clutch.
Then the ECM compares the engagement condition of the lock-up clutch with the lock- up schedule in the ECM memory to detect mechanical troubles of the valve body, Torque converter assembly and automatic transaxle assembly (clutch, brake or gear, etc.).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate | Memory | Note |
|---|---|---|---|---|---|---|---|
| P0741 | Lock up Speed is not Conformable | 1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
1.
The vehicle is being driven. 2.
When the lock-up operates and the engine speed is greatly different from the lock-up speed. 3.
3.5 seconds 4.
2-trip detection logic |
·
Transmission valve body assembly ·
Torque converter clutch assembly ·
ECM ·
Automatic transmission assembly |
Come on | Blinks | DTC stored | - |
MIL:"Comes on" means the MIL (Malfunction Indicator Light) illuminates.
Memory:"DTC stored" means the ECM stores the trouble code if the ECU detects the DTC detection condition.
Refer to the HYDRAULIC TEST.
Click hereDrivetrain>A4R AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSMISSION SYSTEM>HYDRAULIC TEST
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Refer to the TORQUE CONVERTER AND DRIVE PLATE.
Click hereDrivetrain>A4R AUTOMATIC TRANSMISSION / TRANSAXLE>TORQUE CONVERTER AND DRIVE PLATE>INSPECTION
The Torque converter assembly operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG