Home › Drivetrain › A4R AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION WIRE › from 2015.08
RM19Y0E _52 Drivetrain _041457 A4R AUTOMATIC TRANSMISSION / TRANSAXLE _0197962 TRANSMISSION WIRE A

A4R AUTOMATIC TRANSMISSION / TRANSAXLE  TRANSMISSION WIRE  INSTALLATION  


PROCEDURE

Hide 82125J 2.INSTALL TRANSMISSION WIRE

NOTICE:
·

Clean the bolts with compressed air before installation.

·

Make sure not to drop the manual valve.



a.

Connect the connector of the transmission wire.


b.
C325147N02
1.208,0.229 1.365,0.427 0.156,0.198 10 false A 1.802,0.146 1.958,0.344 0.156,0.198 10 false A 3.177,0.656 3.333,0.854 0.156,0.198 10 false A 2.177,0.125 2.333,0.323 0.156,0.198 10 false B 1.365,3.198 1.521,3.396 0.156,0.198 10 false C 3.188,1.49 3.344,1.688 0.156,0.198 10 false C

Temporarily install the transmission valve body assembly with the 6 bolts.

Bolt length:

35 mm (1.38 in.) for bolt A

45 mm (1.77 in.) for bolt B

16 mm (0.63 in.) for bolt C



c.

Tighten the 6 bolts to the specified torque.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


d.

Install the ATF temperature sensor with the bolt.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)


e.

Connect the 6 connectors.


Hide 35409D 3.INSTALL MANUAL DETENT SPRING SUB-ASSEMBLY

Hide 35106 6.INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

Hide 35103 7.INSTALL TRANSMISSION OIL LEVEL DIPSTICK SUB-ASSEMBLY

Hide 51202D 8.INSTALL FRONT LOWER SUSPENSION CROSSMEMBER SUB-ASSEMBLY

a.
C267359N01
0.167,1.406 0.542,1.781 0.375,0.375 10 A 0.938,1.594 1.313,1.969 0.375,0.375 10 A 2.552,1.448 2.927,1.823 0.375,0.375 10 A 3.198,0.625 3.427,1.115 0.229,0.49 10 A 0.344,0.615 0.802,0.958 0.458,0.344 10 B 2.24,0.292 2.698,0.635 0.458,0.344 10 B

Install the front lower suspension crossmember sub-assembly with the 4 new bolts.

Torque:
Bolt A : 100 N*m (1020 kgf*cm, 74 ft.*lbf)


b.

Install the front lower suspension crossmember sub-assembly with the 2 new bolts.

Torque:
Bolt B : 100 N*m (1020 kgf*cm, 74 ft.*lbf)


Hide 9.ADD AUTOMATIC TRANSMISSION FLUID

Hide 11.INSPECT FOR FLUID LEAK

Hide 51443 12.INSTALL NO. 2 ENGINE UNDER COVER (w/ No. 2 Engine Under Cover)

Hide 13.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT