The vehicle stability control system troubleshooting procedures are based on the premise that the CAN communication system is functioning normally. Check the CAN communication system first before troubleshooting the vehicle stability control system.
*: Use the GTS.
| Result |
|---|
| NEXT |
NEXT
Interview the customer and confirm the trouble.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
| Result |
|---|
| NEXT |
NEXT
Check and record DTC and Freeze Frame Data.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR for DTC Check/Clear
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>FREEZE FRAME DATA for Freeze Frame Data
Clear the DTC and Freeze Frame Data.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR for DTC Check/Clear
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>FREEZE FRAME DATA for Freeze Frame Data
Reconfirm the DTC.
Reconfirm the DTC based on the recorded DTC and Freeze Frame Data.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR for DTC Check/Clear
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>FREEZE FRAME DATA for Freeze Frame Data
If there is no response from the skid control ECU (brake actuator assembly), inspect the IG1 circuit of the skid control ECU (brake actuator assembly).
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>C1241/15
| Proceed to |
|---|
| DTC is output |
| DTC is not output (Problem symptom does not occur) |
| DTC is not output (Problem symptom occurs) |
DTC is output
DTC is not output (Problem symptom does not occur)
DTC is not output (Problem symptom occurs)
Proceed to Diagnostic Trouble Code Chart.
| Result |
|---|
| NEXT |
NEXT
Proceed to Check for Intermittent Problems.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
| Result |
|---|
| NEXT |
NEXT
Proceed to Problem Symptoms Table.
| Result |
|---|
| NEXT |
NEXT
| Result |
|---|
| NEXT |
NEXT
| Result |
|---|
| NEXT |
NEXT
| Result |
|---|
| NEXT |
NEXT
| Result |
|---|
| NEXT |
NEXT