Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2016.09
RM19Y0E _54 Brake _002992 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0288382 VEHICLE STABILITY CONTROL SYSTEM T

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  PROBLEM SYMPTOMS TABLE  


NOTICE:

When replacing the skid control ECU (brake actuator assembly), sensor, etc., turn the ignition switch off.


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Vehicle Stability Control System
Symptom Suspected Area Link
ABS, BA and/or EBD does not operate Check for DTCs again and make sure that the normal system code is output. Click here
Power source circuit (low power supply voltage malfunction) Click here
Power source circuit (high power supply voltage malfunction) Click here
Front speed sensor circuit (open or short malfunction) Click here
Front speed sensor circuit (output malfunction) Click here
Rear speed sensor circuit (open or short malfunction) Click here
Rear speed sensor circuit (output malfunction) Click here
Check the skid control ECU (brake actuator assembly) with the Techstream. (Check skid control ECU (brake actuator assembly) operation using the Active Test function.) If abnormal, check the hydraulic circuit for leaks. Click here
If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly). Click here
ABS, BA and/or EBD does not operate efficiently Check for DTCs again and make sure that the normal system code is output. Click here
Front speed sensor circuit (open or short malfunction) Click here
Front speed sensor circuit (output malfunction) Click here
Rear speed sensor circuit (open or short malfunction) Click here
Rear speed sensor circuit (output malfunction) Click here
Stop light switch circuit Click here
Check the skid control ECU (brake actuator assembly) with the Techstream. (Check skid control ECU (brake actuator assembly) operation using the Active Test function.) If abnormal, check the hydraulic circuit for leaks. Click here
If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly). Click here
ABS sensor DTC check cannot be done Check for DTCs again and make sure that the normal system code is output. Click here
If the symptoms still occur even after the above circuit in the suspected area has been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly). Click here
ABS warning light abnormal (Remains on) ABS warning light circuit Click here
Skid control ECU (brake actuator assembly) Click here
ABS warning light abnormal (Does not come on) ABS warning light circuit Click here
Skid control ECU (brake actuator assembly) Click here
Brake system warning light abnormal (Remains on) Brake system warning light (red indicator) circuit Click here
Skid control ECU (brake actuator assembly) Click here
Brake system warning light abnormal (Does not come on) Brake system warning light (red indicator) circuit Click here
Skid control ECU (brake actuator assembly) Click here
VSC and/or TRC does not operate Check for DTCs again and make sure that the normal system code is output. Click here
Power source circuit (low power supply voltage malfunction) Click here
Power source circuit (high power supply voltage malfunction) Click here
Check the hydraulic circuit for leaks. -
Front speed sensor circuit (open or short malfunction) Click here
Front speed sensor circuit (output malfunction) Click here
Rear speed sensor circuit (open or short malfunction) Click here
Rear speed sensor circuit (output malfunction) Click here
Steering sensor (switch base) circuit (open or short malfunction) Click here
Yaw rate sensor circuit (open or short malfunction) Click here
G sensor circuit (open or short malfunction) Click here
If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly). Click here
VSC sensor DTC check cannot be done Check for DTCs again and make sure that the normal system code is output. Click here
If the symptoms still occur even after the above circuit in suspected areas has been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly). Click here
Slip indicator light abnormal (Remains on) Slip indicator light circuit Click here
Skid control ECU (brake actuator assembly) Click here
Slip indicator light abnormal (Does not come on) Slip indicator light circuit Click here
Skid control ECU (brake actuator assembly) Click here
Sensor check cannot be done Skid control ECU (brake actuator assembly) Click here