Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2016.09
RM19Y0E _54 Brake _002992 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0288382 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C0226/52  FR Solenoid Open / Short  C0236/54  FL Solenoid Open / Short  C0246/56  RR Solenoid Open / Short  C0256/58  RL Solenoid Open / Short  C1225/61  Master Cut Solenoid Open / Short  


DESCRIPTION

These solenoids turn on when signals are received from the skid control ECU (brake actuator assembly) and they control the pressure acting on the wheel cylinders to control the braking force.

Each solenoid operates by receiving signals from the solenoid relay inside the skid control ECU.

To control the vehicle, each solenoid regulates the pressure imposed on each wheel and cylinder based on signals from the skid control ECU (brake actuator assembly).

DTC No. Detection Item DTC Detection Condition Trouble Area Note
C0226/52 FR Solenoid Open / Short With ignition switch ON, abnormality occurs in the corresponding retention solenoid valve and decompression solenoid valve in the brake actuator. Skid control ECU (Brake actuator assembly) -
C0236/54 FL Solenoid Open / Short With ignition switch ON, abnormality occurs in the corresponding retention solenoid valve and decompression solenoid valve in the brake actuator. Skid control ECU (Brake actuator assembly) -
C0246/56 RR Solenoid Open / Short With ignition switch ON, abnormality occurs in the corresponding retention solenoid valve and decompression solenoid valve in the brake actuator. Skid control ECU (Brake actuator assembly) -
C0256/58 RL Solenoid Open / Short With ignition switch ON, abnormality occurs in the corresponding retention solenoid valve and decompression solenoid valve in the brake actuator. Skid control ECU (Brake actuator assembly) -
C1225/61 Master Cut Solenoid Open / Short With ignition switch ON, abnormality occurs in the corresponding solenoid valve in the brake actuator. Skid control ECU (Brake actuator assembly) -

HINT:

Solenoids correspond to DTCs are listed below.

DTC No. Corresponding solenoid
C0226/52 SFRH, SFRR
C0236/54 SFLH, SFLR
C0246/56 SRRH, SRRR
C0256/58 SRLH, SRLR
C1225/61 SM1, SM2


CAUTION / NOTICE / HINT

NOTICE:

If the skid control ECU (brake actuator assembly) is replaced with a new one, the skid control ECU (brake actuator assembly) makes the shift to test mode automatically when the ignition switch is turned to ON for the first time. Be sure to complete the test mode checks.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>TEST MODE PROCEDURE


HINT:

If DTCs C0273/13 and C0273/14 are output at the same time as C1241/15, perform troubleshooting for C1241/15 first.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>C1241/15


PROCEDURE

1.REPLACE BRAKE ACTUATOR ASSEMBLY
a.

Replace the brake actuator assembly.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR>REMOVAL


Result:
Proceed to
NEXT



NEXT

END