Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2016.09
RM19Y0E _54 Brake _002992 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0288382 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1246/43  Abnormal Signal of Master Hydraulic Sensor  C1281/95  Master Hydraulic Pressure System (Check Mode)  


DESCRIPTION

The master cylinder pressure sensor is built into the brake actuator assembly, and detects the master cylinder pressure based on the power supply from the skid control ECU. The master cylinder pressure sensor then outputs the detected pressure value to the skid control ECU.

If the DTCs relating to open/short/abnormal output of the master hydraulic sensor, and the DTCs relating to the stop lamp SW open wire (C1249/39) are output at the same time, perform troubleshooting for the stop light switch assembly first.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
C1246/43 Abnormal Signal of Master Hydraulic Sensor With ignition switch ON or during driving at higher speeds than a set speed, abnormal output value from the master cylinder pressure sensor is detected.
·

Stop light switch assembly

·

Wire harness or connector

·

Skid control ECU (brake actuator assembly)


-
C1281/95 Master Hydraulic Pressure System (Check Mode) Stored during Test Mode. Skid control ECU (brake actuator assembly) -

DTC Detection Conditions: C1246/43
Vehicle Condition
Pattern 1 Pattern 2
Diagnosis Condition Ignition Switch ON ○ -
When driving at higher speeds than a set speed. - ○
Malfunction Status Abnormal output value from the master cylinder pressure sensor is detected. ○ ○
Detection Time - -
Number of Trips - -

CAUTION / NOTICE / HINT

NOTICE:

If the skid control ECU (brake actuator assembly) is replaced with a new one, the skid control ECU (brake actuator assembly) makes the shift to test mode automatically when the ignition switch is turned to ON for the first time. Be sure to complete the test mode checks.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>TEST MODE PROCEDURE


PROCEDURE

1.CHECK STOP LIGHT OPERATION
a.

Check that the stop lights come on when the brake pedal is depressed and go off when the brake pedal is released.

OK:
Condition Illumination Condition
Brake pedal depressed. On
Brake pedal released. Off



Result:
Proceed to
OK
NG



OK

2.READ VALUE USING GTS (MASTER PRESSURE SENSOR 1)

NG

GO TO LIGHTING SYSTEM (PROBLEM SYMPTOMS TABLE)

2.READ VALUE USING GTS (MASTER PRESSURE SENSOR 1)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / ABS/VSC/TRC / Data List.


e.

Read the Data List according to the display on the GTS.

Chassis > ABS/VSC/TRC > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Master pressure sensor 1 Master cylinder pressure sensor 1 reading Min.: 0.00 V
Max.: 5.00 V
Brake pedal released: 0.50 V Reading increases when brake pedal is depressed

OK:

Normal



Result:
Proceed to
OK
NG



OK

3.RECONFIRM DTC

NG

3.RECONFIRM DTC


Result:
Result Proceed to
DTC is not output A
DTC relating to master cylinder pressure sensor is output B



A

B