1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
2.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
45100
4.REMOVE STEERING WHEEL ASSEMBLY
45287
5.REMOVE LOWER STEERING COLUMN COVER
45286B
6.REMOVE UPPER STEERING COLUMN COVER
45107
7.REMOVE HORN BUTTON WIRE SUB-ASSEMBLY (w/o Steering Pad Switch)
Disconnect the horn button wire sub-assembly from the spiral cable sub-assembly.
84306
8.REMOVE SPIRAL CABLE SUB-ASSEMBLY (w/o VSC)
| *1 | Lock Slider |
| *2 | Airbag Connector
(Yellow Colored) |
Pull the lock slider in the direction indicated by the arrow to release the connector lock and disconnect the airbag connector (yellow colored) from the spiral cable sub-assembly.
When handling the airbag connector, take care not to damage the airbag wire harness.
Disconnect the connector from the spiral cable sub-assembly.
Disengage the 3 claws to remove the spiral cable sub-assembly.
84140
9.REMOVE HEADLAMP DIMMER SWITCH ASSEMBLY (w/ VSC)
84650
10.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY (w/ VSC)
84941A
11.REMOVE SWITCH BASE (w/ VSC)
| *1 | Lock Slider |
| *2 | Airbag Connector
(Yellow Colored) |
Pull the lock slider in the direction indicated by the arrow to release the connector lock and disconnect the airbag connector (yellow colored) from the switch base.
When handling the airbag connector, take care not to damage the airbag wire harness.
Disconnect the 2 connectors from the switch base.
Using pliers, expand the clamp as shown in the illustration.
While holding the clamp expanded, disengage the claw and 2 guides to remove the switch base.