PROCEDURES NECESSARY WHEN CABLE IS DISCONNECTED/RECONNECTED TO BATTERY TERMINAL
PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED
Automatic transmission assembly
Valve body assembly
Any of the shift solenoid valve
Engine assembly
ECM
Tire pressure warning ECU and receiver
Tire pressure warning valve and transmitter
Transmitter ID registration
Initialization
When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates.
Tire pressure warning function
Brake actuator assembly (Skid control ECU)
DTCs are output
ABS warning light illumination
Slip indicator light illumination
VSC disable or malfunctioning
Steering Sensor (Switch Base)
Transponder key ECU assembly
Key
Door control transmitter
Main body ECU (Fuse block assembly)
Front door window regulator assembly RH*1
Front door window regulator assembly LH*2
Power window regulator motor assembly RH*1
Power window regulator motor assembly LH*2
Power window regulator master switch assembly
Auto up and down function
Jam protection function
Key-off operation function
*1: for RHD
*2: for LHD