Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR › from 2016.09
RM19Y0E _54 Brake _002992 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0288385 STEERING ANGLE SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  STEERING ANGLE SENSOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


Hide 2.PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 45100 4.REMOVE STEERING WHEEL ASSEMBLY

Hide 45287 5.REMOVE LOWER STEERING COLUMN COVER

Hide 45286B 6.REMOVE UPPER STEERING COLUMN COVER

Hide 45107 7.REMOVE HORN BUTTON WIRE SUB-ASSEMBLY (w/o Steering Pad Switch)

a.

Disconnect the horn button wire sub-assembly from the spiral cable sub-assembly.


Hide 84140 8.REMOVE HEADLAMP DIMMER SWITCH ASSEMBLY

Hide 84650 9.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

Hide 84941A 10.REMOVE SWITCH BASE

a.
B463020C01
0.573,3.208 0.74,3.115 true 2.385,3.208 2.563,3.146 true 0.375,3.167 0.594,3.323 0.219,0.156 10 false *1 2.167,3.156 2.469,3.333 0.302,0.177 10 false *2
*1 Lock Slider
*2 Airbag Connector
(Yellow Colored)


Pull the lock slider in the direction indicated by the arrow to release the connector lock and disconnect the airbag connector (yellow colored) from the switch base.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



b.

Disconnect the 2 connectors from the switch base.


c.
B456221

Using pliers, expand the clamp as shown in the illustration.


d.

While holding the clamp expanded, disengage the claw and 2 guides to remove the switch base.