Home › Engine / Hybrid System › 2ZR-FXE (COOLING) › THERMOSTAT › 2016.10–2020.08
RM32K0E _51 Engine / Hybrid System _060780 2ZR-FXE COOLING _0298027 THERMOSTAT A

2ZR-FXE COOLING  THERMOSTAT  INSTALLATION  


PROCEDURE

Hide 16031 1.INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

a.

Type A:

i.

Install a new gasket to the water inlet with thermostat sub-assembly.


ii.

Install the water inlet with thermostat sub-assembly with the 2 nuts and bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)



b.

Type B:

i.

Install a new gasket to the water inlet with thermostat sub-assembly.


ii.

Install the water inlet with thermostat sub-assembly with the 3 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)



c.

Connect the No. 2 radiator hose and No. 3 water by-pass hose to the water inlet with thermostat sub-assembly and slide the 2 clips to secure them.


Hide 11452 2.INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE

a.

Install a new engine oil level dipstick guide O-ring to the engine oil level dipstick guide.


b.

Apply a light coat of engine oil to the engine oil level dipstick guide O-ring.


c.

Insert the engine oil level dipstick guide end into the oil pan sub-assembly.


d.

Install the engine oil level dipstick guide to the cylinder block sub-assembly with the bolt.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


e.

Engage the clamp to connect the engine wire to the engine oil level dipstick guide.


Hide 15301 3.INSTALL ENGINE OIL LEVEL DIPSTICK

a.

Install the engine oil level dipstick to the engine oil level dipstick guide.


Hide 17751 4.INSTALL NO. 1 AIR CLEANER INLET

Hide 17701 6.INSTALL AIR CLEANER CASE SUB-ASSEMBLY

Hide 17801 7.INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 17705 8.INSTALL AIR CLEANER CAP SUB-ASSEMBLY

Hide 17752 9.INSTALL NO. 2 AIR CLEANER INLET

Hide 53141F 10.INSTALL RADIATOR COVER

Hide 11.ADD ENGINE COOLANT (for Engine)

Hide 12.INSPECT FOR COOLANT LEAK (for Engine)

Hide 51441 13.INSTALL NO. 1 ENGINE UNDER COVER