The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear axle carrier sub-assembly removal/installation are shown below.
*1: When performing learning using the GTS.
*2: w/ Height Control Sensor
When removing or installing the rear disc brake caliper assembly, pushing back the disc brake piston may cause a large clearance between the brake pads and brake disc. When the brake pedal is depressed with a large clearance between the brake pads and the brake disc, DTC C1214 related to abnormal brake fluid pressure may be stored. Make sure to clear any DTCs after performing this step.
While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISABLE BRAKE CONTROL
Click hereBrake>BRAKE (FRONT)>FRONT BRAKE>REMOVAL
3.REMOVE REAR WHEEL
4.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
42431
5.REMOVE REAR DISC
Click hereBrake>BRAKE (REAR)>REAR BRAKE>REMOVAL
6.DISCONNECT SKID CONTROL SENSOR WIRE
42450B
7.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY
8.REMOVE FLEXIBLE HOSE BRACKET
Remove the bolt and flexible hose bracket from the rear axle carrier sub-assembly.
89408C
9.REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Height Control Sensor)
48840A
10.REMOVE REAR STABILIZER LINK ASSEMBLY
48231B
11.REMOVE REAR COIL SPRING
48258C
12.REMOVE REAR LOWER COIL SPRING INSULATOR
48720A
13.REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY
14.REMOVE REAR AXLE CARRIER SUB-ASSEMBLY
Loosen the 2 bolts of the rear trailing arm assembly.
| *1 | Rear Axle Carrier Pin |
Loosen the nut of the rear shock absorber assembly.
Hold the rear axle carrier pin while rotating the nut.
| *a | Wooden Block |
| *b | Jack |
Using a jack and a wooden block, support the rear axle carrier sub-assembly.
When jacking up the rear axle carrier sub-assembly, be sure to jack it up slowly.
Make sure to perform this operation with the vehicle kept as low as possible.
Loosen the bolt (A).
Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.
Remove the 2 bolts and separate the rear trailing arm assembly from the rear axle carrier sub-assembly.
Remove the nut and separate the rear shock absorber assembly from the rear axle carrier sub-assembly.
Hold the rear axle carrier pin while rotating the nut.
Remove the bolt (A), nut and rear axle carrier sub-assembly from the rear upper control arm assembly.
Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.