The rear center ultrasonic sensor (RH) is installed on the rear bumper. The ECU detects obstacles based on signals received from the rear center ultrasonic sensor (RH). If the rear center ultrasonic sensor (RH) has an open circuit or other malfunction, it will not function normally.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AE8 | Rear Right Center Sensor Malfunction | Either condition is met (1 trip detection logic*):
·
A malfunction of the rear center ultrasonic sensor (RH) ·
A short or open in the harness or connector |
·
Rear center ultrasonic sensor (RH) ·
Harness or connector ·
Clearance warning ECU assembly |
*: Only output while a malfunction is present.
| Vehicle Condition | ||||
|---|---|---|---|---|
| Pattern 1 | Pattern 2 | Pattern 3 | ||
| Diagnosis Condition | Power switch on (IG) | ○ | ○ | ○ |
| Malfunction Status | A malfunction of the rear center ultrasonic sensor (RH) | ○ | - | - |
| A short in the harness or connector | - | ○ | - | |
| An open in the harness or connector | - | - | ○ | |
| Detection Time | - | - | - | |
| Number of Trips | 1 trip | 1 trip | 1 trip | |
DTC will be output when conditions for either of the patterns in the table above are met.
If DTCs are output after repairs, turn the power switch on (IG) and the simple intelligent parking assist system on. Then clear the DTCs.
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization may be needed. Refer to Calibration.
Disconnect the F34 clearance warning ECU assembly connector.
Disconnect the P4 rear center ultrasonic sensor (RH) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F34-11 (E1) - P4-1 (EI) | Always | Below 1 Ω |
| F34-8 (BOR) - P4-3 (BI) | Always | Below 1 Ω |
| F34-5 (S3) - P4-2 (SI) | Always | Below 1 Ω |
| F34-11 (E1) - F34-5 (S3) | Always | 10 kΩ or higher |
| F34-8 (BOR) - F34-5 (S3) | Always | 10 kΩ or higher |
| F34-11 (E1) - F34-8 (BOR) | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the rear center ultrasonic sensor (RH) with a known good one.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Rear)>REMOVAL
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Check for DTCs.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG