86011A
1.INSTALL RADIO SETTING CONDENSER
Engage the claw to install a new terminal cover to the wire harness.
Make sure to hold the crimping side of the terminal when installing the wire harness to the terminal cover.
Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.
Do not use excessive force when inserting the wire harness into the terminal cover.
If the terminal cover has been deformed during installation, replace the terminal and terminal cover with new ones.
Engage the 6 claws to install the 2 new terminal covers with wire harness to a new radio setting condenser condenser.
Do not use excessive force when inserting the terminal covers into the condenser.
If a terminal cover has been deformed during installation, replace the terminal, terminal covers and radio setting condenser with new ones.
Insert the cover as shown in the illustration and engage the claw.
Engage the clamp to temporarily install the radio setting condenser with wire harness.
Install the radio setting condenser with the bolt.
64740C
2.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
64715C
3.INSTALL DECK TRIM SIDE COVER LH (w/ Cover)
4.INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (w/ Luggage Compartment Room Light)
64716D
5.INSTALL DECK TRIM REAR COVER
62552F
6.INSTALL REAR SEAT SIDE GARNISH LH
76974F
7.INSTALL REAR UNDER SIDE COVER LH
71304C
8.INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY LH
62332A
9.CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
67918A
10.INSTALL REAR DOOR SCUFF PLATE LH
11.INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY
64997
12.INSTALL DECK FLOOR BOX LH (w/ Deck Floor Box)
64995
13.INSTALL DECK FLOOR BOX RH (w/ Deck Floor Box)
64777J
14.INSTALL SPARE WHEEL CUSHION (w/ Deck Board)
58410B
15.INSTALL DECK BOARD ASSEMBLY (w/ Deck Board)
64910J
16.INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
64330D
17.INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)