1.REMOVE FRONT WHEEL RH
53851D
2.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH
Remove the 5 screws and front wheel opening extension pad RH.
75601A
3.REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY RH
4.REMOVE BODY ROCKER PANEL MOULDING ASSEMBLY RH
53875A
5.REMOVE FRONT FENDER LINER RH
Using a screwdriver, turn the pin 90 degrees counterclockwise and remove the pin hold clips.
Remove the 6 screws, 6 clips and front fender liner RH.
6.DRAIN WASHER FLUID
Disconnect the rear washer hose from the windshield washer motor and pump assembly, and drain the washer fluid.
Use a container to collect the washer fluid.
85310
7.REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY
|
Remove in this Direction |
Disconnect the washer hose.
Disconnect the connector.
Remove the windshield washer motor and pump assembly as shown in the illustration.