Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM
RM32K0E _58 Vehicle Interior _062180 METER / GAUGE / DISPLAY _0304590 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Steering Pad Switch Circuit  


DESCRIPTION

The combination meter assembly and steering pad switch assembly are connected via direct line. The main display and multi-information display in the combination meter assembly are operated using the switches of the steering pad switch assembly.

WIRING DIAGRAM

C369237E05
0.365,1.594 0.75,1.854 0.385,0.26 10 false Right 1.083,1.615 1.521,1.854 0.438,0.24 10 false Down 1.979,1.583 2.417,1.823 0.438,0.24 10 false Up 2.677,1.583 3.115,1.823 0.438,0.24 10 false Left 1.094,2.104 1.531,2.344 0.438,0.24 10 false Back 1.938,2.094 2.375,2.333 0.438,0.24 10 false Trip 2.573,2.083 3.01,2.323 0.438,0.24 10 false Enter 0.938,3.188 2.958,3.438 2.021,0.25 10 false Steering Pad Switch Assembly 4.208,1.188 4.438,1.396 0.229,0.208 10 false 2 4.167,1.354 4.396,1.563 0.229,0.208 10 false z1 4.177,2.333 4.406,2.542 0.229,0.208 10 false z1 4.177,2.833 4.406,3.042 0.229,0.208 10 false z1 4.208,2.177 4.438,2.385 0.229,0.208 10 false 3 4.198,2.656 4.427,2.865 0.229,0.208 10 false 8 5.24,1.177 5.469,1.385 0.229,0.208 10 false 10 5.208,1.354 5.573,1.573 0.365,0.219 10 false F29 5.198,2.344 5.563,2.563 0.365,0.219 10 false F29 5.208,2.833 5.573,3.052 0.365,0.219 10 false F29 5.219,2.167 5.448,2.375 0.229,0.208 10 false 11 5.271,2.667 5.5,2.875 0.229,0.208 10 false 3 4.813,1.281 5.281,1.49 0.469,0.208 10 false +DP 4.75,2.26 5.219,2.469 0.469,0.208 10 false +DP2 4.823,2.75 5.292,2.958 0.469,0.208 10 false EAU 4.052,3.188 5.583,3.604 1.531,0.417 10 false Spiral Cable with Sensor Sub-assembly 5.677,1.271 5.906,1.479 0.229,0.208 10 false 28 5.667,2.24 5.896,2.448 0.229,0.208 10 false 33 5.896,1.281 6.417,1.479 0.521,0.198 10 false MSM+ 5.906,2.26 6.427,2.458 0.521,0.198 10 false MSSL 6.469,1.656 6.719,1.938 0.25,0.281 10 false I/F 5.844,3.177 6.156,3.365 0.313,0.188 10 false F4 5.833,3.323 7.031,3.74 1.198,0.417 10 false Combination Meter Assembly

CAUTION / NOTICE / HINT

NOTICE:

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.


PROCEDURE

1.INSPECT STEERING PAD SWITCH ASSEMBLY
a.

Remove the steering pad switch assembly.

Click hereSteering>STEERING COLUMN>STEERING PAD SWITCH>REMOVAL


b.

Inspect the steering pad switch assembly.

Click hereSteering>STEERING COLUMN>STEERING PAD SWITCH>INSPECTION


Result:
Proceed to
OK
NG



OK

2.INSPECT SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

NG

REPLACE STEERING PAD SWITCH ASSEMBLY

2.INSPECT SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
a.

Remove the spiral cable with sensor sub-assembly.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>REMOVAL


b.

Inspect the spiral cable with sensor sub-assembly.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>INSPECTION


Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY - COMBINATION METER ASSEMBLY)

NG

REPLACE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

3.CHECK HARNESS AND CONNECTOR (SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY - COMBINATION METER ASSEMBLY)
a.

Disconnect the F4 combination meter assembly connector.


b.

Disconnect the F29 spiral cable with sensor sub-assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F4-28 (MSM+) - F29-10 (+DP) Always Below 1 Ω
F4-33 (MSSL) - F29-11 (+DP2) Always Below 1 Ω
F29-3 (EAU) - Body ground Always Below 1 Ω
F4-28 (MSM+) - Body ground Always 10 kΩ or higher
F4-33 (MSSL) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR