G9509
1.INSTALL NO. 2 HV SUPPLY STACK SUB-ASSEMBLY
Be sure to wear insulated gloves and protective goggles.
Install the No. 2 HV supply stack sub-assembly with the 4 nuts.
Engage the claw.
G9508
2.INSTALL NO. 1 HV SUPPLY STACK SUB-ASSEMBLY
Be sure to wear insulated gloves and protective goggles.
Install the No. 1 HV supply stack sub-assembly with the 4 nuts.
Engage the claw.
Connect the connector.
Make sure that the connector is connected securely.
Connect the connector.
Make sure that the connector is connected securely.
G92PD
3.INSTALL NO. 2 HV BATTERY PROTECTOR
89890A
4.INSTALL BATTERY ECU ASSEMBLY
G92PC
5.INSTALL NO. 1 HV BATTERY PROTECTOR
Be sure to wear insulated gloves and protective goggles.
Engage the 2 claws to install the No. 1 HV battery protector to the No. 2 HV battery protector.
Install the 3 nuts.
Engage the clamp to connect the wire harness.
G920Q
6.INSTALL NO. 1 HYBRID BATTERY SHIELD SUB-ASSEMBLY
Be sure to wear insulated gloves and protective goggles.
Install the No. 1 hybrid battery shield sub-assembly to the HV battery with the nut.
Engage the clip.
G929A
7.INSTALL NO. 1 HV BATTERY HOSE
G92D1
8.INSTALL NO. 1 HYBRID BATTERY INTAKE DUCT
Be sure to wear insulated gloves and protective goggles.
Install the No. 1 hybrid battery intake duct to the HV battery with the clip.
Engage the claw of hybrid battery thermistor (sensor portion) to connect the hybrid battery thermistor to the No. 1 hybrid battery intake duct.
G92Z2
9.INSTALL HYBRID BATTERY TERMINAL BLOCK
G92Z0
10.INSTALL HV BATTERY JUNCTION BLOCK ASSEMBLY WITH NO. 2 HYBRID BATTERY SHIELD SUB-ASSEMBLY
G920L
11.INSTALL UPPER NO. 1 HYBRID BATTERY COVER SUB-ASSEMBLY
G9510
12.INSTALL HV BATTERY
13. PERFORM UTILITY
Perform "Battery Status Info Update" after replacing a malfunctioning HV supply stack sub-assembly.
Perform "Prediagnostic Battery Charge" after replacing a malfunctioning HV supply stack sub-assembly.
Perform "Battery Diagnosis" after replacing a malfunctioning HV supply stack sub-assembly.