The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the radio and display receiver assembly removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
Precaution for audio and visual system:
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for M20A-FXS:
Click hereGeneral>MAINTENANCE>M20A-FXS AUXILIARY BATTERY>REMOVAL
for 2ZR-FXE:
Click hereGeneral>MAINTENANCE>2ZR-FXE AUXILIARY BATTERY>REMOVAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
55470
3.REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY
55406B
4.REMOVE INSTRUMENT CLUSTER FINISH LOWER CENTER PANEL SUB-ASSEMBLY
55670A
5.REMOVE INSTRUMENT PANEL CENTER REGISTER ASSEMBLY
86140A
6.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET
Remove the 4 screws.
|
Remove in this Direction |
Pull the radio and display receiver assembly with bracket toward the rear of the vehicle to disengage the claws and clips as shown in the illustration.
Disconnect each connector and remove the radio and display receiver assembly with bracket.
55405B
7.REMOVE INSTRUMENT CLUSTER FINISH CENTER PANEL SUB-ASSEMBLY
Disengage the claws to remove the instrument cluster finish center panel sub-assembly.
86211J
8.REMOVE NO. 1 RADIO RECEIVER BRACKET
Remove the 2 screws and No. 1 radio receiver bracket from the radio and display receiver assembly.
86212C
9.REMOVE NO. 2 RADIO RECEIVER BRACKET
Remove the 2 screws and No. 2 radio receiver bracket from the radio and display receiver assembly.