The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the curtain shield airbag assembly removal/installation are shown below.
After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
Use the same procedure for RHD and LHD vehicles.
The following procedure is for LHD vehicles.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for M20A-FXS:
Click hereGeneral>MAINTENANCE>M20A-FXS AUXILIARY BATTERY>REMOVAL
for 2ZR-FXE:
Click hereGeneral>MAINTENANCE>2ZR-FXE AUXILIARY BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.REMOVE ROOF HEADLINING ASSEMBLY
62180A
4.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY
|
Deployment Side |
When storing the curtain shield airbag assembly, keep the airbag deployment side facing upward.
When removing the curtain shield airbag assembly, have assistants hold it to prevent it from bending.
Check that the power switch off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
| *a | Airbag Connector |
| *b | Airbag Connector Lock |
| *c | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, release the airbag connector lock and disconnect the airbag connector.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Using needle nose pliers, remove the pins from the clips.
Do not damage the pins.
| *1 | Clip | *2 | Curtain Shield Airbag Clip Spacer |
| *a | Pin | *b | Claw (A) |
| *c | Claw (B) | *d | Spacer Location |
Using 2 screwdrivers, disengage the claws (A) of clips to separate the clips from the vehicle body as shown in the illustration.
Separate the clips and curtain shield airbag assembly from the vehicle body as a unit.
Disengage the claws (B).
While holding the curtain shield airbag assembly, remove the 3 bolts and disengage the hooks to remove the curtain shield airbag assembly.
Remove the clips and curtain shield airbag clip spacer from the curtain shield airbag assembly.