The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced the during antenna cord sub-assembly removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
55401E
1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
55086
2.REMOVE NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY (for LHD)
55084E
3.REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY (for RHD)
86101
4.REMOVE ANTENNA CORD SUB-ASSEMBLY (for LHD)
Disengage the clamps to remove the antenna cord sub-assembly.
| *A | w/ USB Audio System | *B | w/ Manual (SOS) Switch |
w/ Manual (SOS) Switch:
Disconnect the connector.
86101
5.REMOVE ANTENNA CORD SUB-ASSEMBLY (for RHD)
Disengage the clamps to remove the antenna cord sub-assembly.
| *A | w/ USB Audio System | - | - |
63311C
6.REMOVE ROOF HEADLINING
86101J
7.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY
for Type A:
Remove each adhesive tape from the roof headlining.
|
Adhesive Tape |
|
Front |
Remove the No. 2 antenna cord sub-assembly from the roof headlining.
for Type B:
Remove each adhesive tape from the roof headlining.
|
Adhesive Tape |
|
Front |
Remove the No. 2 antenna cord sub-assembly from the roof headlining.
for Type C:
Remove each adhesive tape from the roof headlining.
|
Adhesive Tape |
|
Front |
Remove the No. 2 antenna cord sub-assembly from the roof headlining.
86101D
8.REMOVE NO. 3 ANTENNA CORD SUB-ASSEMBLY
for Glass Antenna Type:
Disconnect the connector of the No. 4 antenna cord sub-assembly.
Disconnect the connector.
Disengage the clamps.
w/ Manual (SOS) Switch:
| *a | Guide |
| *b | Clamp |
Disconnect the connector of the floor wire.
Remove the bolt.
Disengage the clamp and guide to remove the No. 3 antenna cord sub-assembly.
w/o Manual (SOS) Switch:
| *a | Guide |
| *b | Clamp |
Remove the bolt.
Disengage the clamp and guide to remove the No. 3 antenna cord sub-assembly.