This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
89458
1.INSTALL FUEL PRESSURE SENSOR
Perform "Inspection After Repair" after replacing the fuel pressure sensor.
Click hereEngine / Hybrid System>M20A-FXS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION
| *a | Cutout (Fuel Delivery Pipe) |
| *b | Cutout (Fuel Pressure Sensor) |
Temporarily install a new fuel pressure sensor to the fuel delivery pipe as shown in the illustration.
Make sure that the cutout of the fuel delivery pipe is aligned with the cutout of the fuel pressure sensor.
| *a | Cutout (Fuel Pressure Sensor) |
| *b | Cutout (No. 1 Fuel Pressure Sensor Holder) |
Temporarily install the No. 1 fuel pressure sensor holder to the fuel delivery pipe as shown in the illustration.
Make sure that the cutout of the fuel pressure sensor is aligned with the cutout of the No. 1 fuel pressure sensor holder.
Using an 8 mm socket wrench, install the 2 bolts.
17111
2.INSTALL INTAKE MANIFOLD
3.CONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
4. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
5.INSPECT FOR FUEL LEAK
6.PERFORM INITIALIZATION
Perform "Inspection After Repair" after replacing the fuel pressure sensor.
Click hereEngine / Hybrid System>M20A-FXS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION