The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced the during headlight assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
If the headlight ECU sub-assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for 2ZR-FXE:
Click hereGeneral>MAINTENANCE>2ZR-FXE AUXILIARY BATTERY>REMOVAL
for M20A-FXS:
Click hereGeneral>MAINTENANCE>M20A-FXS AUXILIARY BATTERY>REMOVAL
3.REMOVE FRONT BUMPER ASSEMBLY
85319A
4.SEPARATE INLET HOSE (for RH Side)
Remove the clip to separate the inlet hose.
5.REMOVE HEADLIGHT ASSEMBLY
|
Protective Tape |
Apply protective tape around the headlight assembly as shown in the illustration.
| *a | Connector Lock Lever |
|
Remove in this Direction |
Disconnect the connector A.
Disengage the claw, pull down the connector lock lever as shown in the illustration to disconnect the connector B.
Remove the bolt and 3 screws.
|
Remove in this Direction |
Remove the headlight assembly as shown in the illustration.