Home › Engine / Hybrid System › CRUISE CONTROL › FRONT RADAR SENSOR SYSTEM › from 2020.08
RM32K0E _51 Engine / Hybrid System _061336 CRUISE CONTROL _0441045 FRONT RADAR SENSOR SYSTEM C

CRUISE CONTROL  FRONT RADAR SENSOR SYSTEM  U030051  Internal Control Module Software Incompatibility Not Programmed  U030057  Internal Control Module Software Incompatibility Invalid/Incompatible Software Component  


DESCRIPTION

The millimeter wave radar sensor assembly receives vehicle information from the hybrid vehicle control ECU via the CAN communication line. If the millimeter wave radar sensor assembly cannot confirm the vehicle information sent from the hybrid vehicle control ECU, the millimeter wave radar sensor assembly stores DTC U030051.

The millimeter wave radar sensor assembly receives vehicle information from the hybrid vehicle control ECU via the CAN communication line. If the vehicle information stored in the millimeter wave radar sensor assembly does not match the vehicle information sent from the hybrid vehicle control ECU, the millimeter wave radar sensor assembly stores DTC U030057.

DTC No. Detection Item DTC Detection Condition Trouble Area
U030051 Internal Control Module Software Incompatibility Not Programmed The millimeter wave radar sensor assembly cannot confirm the vehicle information sent from the hybrid vehicle control ECU.
·

Hybrid Control System

·

Hybrid Vehicle Control ECU

·

Millimeter Wave Radar Sensor Assembly


U030057 Internal Control Module Software Incompatibility Invalid/Incompatible Software Component The vehicle information stored in the millimeter wave radar sensor assembly does not match the vehicle information sent from the hybrid vehicle control ECU.
·

Hybrid Control System

·

Hybrid Vehicle Control ECU

·

Millimeter Wave Radar Sensor Assembly



CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle and a DTC may be stored.

·

When the millimeter wave radar sensor assembly has been replaced with a new one, it is necessary to perform millimeter wave radar sensor assembly beam axis alignment and to clear the vehicle control history. Before performing the Driving Adjustment, make sure to read Before Starting Driving Adjustment.

HINT:

Beam axis alignment of the millimeter wave radar sensor assembly can be performed using either Triangle Target, Flat Surface Target or Driving Adjustment.

Triangle Target: Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>TARGET ADJUSTMENT(TRIANGLE TARGET)

Flat Surface Target: Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>TARGET ADJUSTMENT(FLAT SURFACE TARGET)

Driving Adjustment: Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>DRIVING ADJUSTMENT


·

Before replacing the hybrid vehicle control ECU, refer to Service Bulletin.



PROCEDURE

1.CHECK FOR DTC (HYBRID CONTROL)
a.

Check for DTCs of hybrid control system.

Powertrain > Hybrid Control > Trouble Codes
50001 397

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

2.CHECK FOR DTCs (HEALTH CHECK)

B

2.CHECK FOR DTCs (HEALTH CHECK)
a.

Using the GTS, perform a health check.

OK:

ECUs other than the millimeter wave radar sensor assembly do not output specification information mismatch DTCs related to the hybrid vehicle control ECU.



Result:
Proceed to
OK
NG



OK

3.CHECK HYBRID VEHICLE CONTROL ECU

NG

3.CHECK HYBRID VEHICLE CONTROL ECU
a.

Check that the hybrid vehicle control ECU that is installed is a Toyota genuine part.

OK:

The hybrid vehicle control ECU that is installed is a Toyota genuine part



Result:
Proceed to
OK
NG



OK

4.CHECK FOR DTC (FRONT RADAR SENSOR)

NG

4.CHECK FOR DTC (FRONT RADAR SENSOR)
a.

Check for DTCs.

Body Electrical > Front Radar Sensor > Trouble Codes
50001 429

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

END

B

REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY