The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during HV floor under wire removal/installation are shown below.
Orange wire harnesses and connectors indicate high-voltage circuits. To prevent electric shock, always follow the procedure described in the repair manual.
Click hereEngine / Hybrid System>M20A-FXS (HYBRID / BATTERY CONTROL)>HYBRID CONTROL SYSTEM>PRECAUTION
Be sure to wear insulating gloves when working on high voltage wiring or components.
If work is performed without wearing insulating gloves, there is a danger of electric shock.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
G3834
2.REMOVE SERVICE PLUG GRIP
82121
3.DISCONNECT ENGINE WIRE
4.REMOVE CONNECTOR COVER ASSEMBLY
5.CHECK TERMINAL VOLTAGE
6.TEMPORARILY INSTALL CONNECTOR COVER ASSEMBLY
821H1
7.DISCONNECT HV FLOOR UNDER WIRE
73350C
8.DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
9.REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY
72693
10.REMOVE REAR SEAT CUSHION LOCK HOOK
67918A
11.REMOVE REAR DOOR SCUFF PLATE LH
76974F
12.REMOVE REAR UNDER SIDE COVER LH
67917A
13.REMOVE REAR DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
76973F
14.REMOVE REAR UNDER SIDE COVER RH
Use the same procedure as for the LH side.
76971G
15.REMOVE REAR UNDER COVER
71033
16.REMOVE REAR SEAT CUSHION LEG SUB-ASSEMBLY
G92N4A
17.REMOVE NO. 1 HV BATTERY COVER PANEL RH
821H1
18.DISCONNECT HV FLOOR UNDER WIRE
57627A
19.REMOVE REAR FLOOR SIDE MEMBER COVER RH
58165B
20.REMOVE FRONT FLOOR COVER RH
Perform the same procedure as for the front floor cover LH.
Click hereEngine / Hybrid System>M20A-FXS (INTAKE / EXHAUST)>EXHAUST MANIFOLD>REMOVAL
51201
21.REMOVE FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY
821H1
22.REMOVE HV FLOOR UNDER WIRE
Be sure to wear insulated gloves.
Remove the 2 nuts.
Remove the 3 clamps.
If the clamps are removed forcibly, the stud bolts may be damaged.
Disengage the grommet and pull out the HV floor under wire from the floor panel hole.
for LHD:
Remove the nut.
Disconnect the connector.
Disengage the 2 clamps.
for RHD:
Disconnect the connector.
Remove the 2 nuts.
Disengage the 3 clamps.
Remove the clamp (A).
Disengage the clamp (B) to remove the HV floor under wire.